Holtkoetter 2508P1 User Manual
ASSEMBLY INSTRUCTIONS FOR
205 Hardman Avenue South, South Saint Paul, MN 55075
Voice: (800) 899-5444 • Fax: (888) 552-8661
e-mail: customerservice@holtkoetter.com
www.holtkoetter.com
Congratulations, you have just purchased the leading-edge dimming technology from Holtkötter
International, Inc. We have specifically designed the “Dimm System Punkt 1” (Dimming System
Point 1 (P1)) to provide specialized features for ease and convenience of use.
Features of the “Dimm System Punkt 1” include:
Point Dimming - the lamp may be turned on with a single click of the P1 dimmer.
Soft On - the lamp will come on low and continue to brighten to full brightness.
This allows the eye to adjust to a gradual increase in light.
Soft / Delayed Off - turn the lamp off with a single click of the P1 dimmer. The
lamp will dim to 60% brightness of the original setting, remaining briefly at that
level to allow you to exit the room; then the lamp gradually turns itself off. This
“soft” off provides a few moments of light after turning the lamp off, rather than
immediate darkness as is the case with other switches.
Dimming Cycle - to adjust the lamp to the perfect light level for any situation,
press and hold the P1 dimmer. The dimmer will cycle through all dimming levels.
When the lamp achieves the light level of your choice, release the P1 dimmer.
Halogen Pharmacy Lamp
No. 2508*P1
featuring “Dimm-System Punkt 1”
Tilt Switch - a safety measure is provided with the “Dimm System Punkt 1”. In the
event that the lamp is tipped over, the tilt switch cuts off the power to the lamp.
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.
Holtkötter ® and Holtkötter Leuchten® are registered trademarks of Holtkötter. All Rights Reserved.
© Holtkötter
ASSEMBLY INSTRUCTIONS FOR
e-mail: customerservice@holtkoetter.com
www.holtkoetter.com
Your “Dimm System Punkt 1” lamp comes fully assembled. If you need to replace a glass shield
or light bulb, or fuse please read the following instructions carefully.
Please save these instructions.
Replace the Glass Shield
1. Be sure to turn the lamp off and allow it to cool before attempting glass shield and/or
bulb replacement.
2. The glass shield is held in place with an aluminum spring clip. To remove this clip, hold
each side and pull firmly from the socket. This will release the glass shield.
3. Place the new glass shield over the curve of the aluminum socket.
4. Press the aluminum clip over the shield and onto the socket, making sure that both
sides snap into place.
Replace the Bulb
1. Follow steps #1 and #2 above to remove the glass shield.
2. To remove the old bulb, hold it by the porcelain grip, push in towards the socket slightly
and turn it counter-clockwise.
3. Install the new bulb, being careful not to touch the bulb envelope with your bare
hands. Hold the bulb at the porcelain grip, push it down slightly and turn it clockwise.
4. Follow steps #3 and #4 above to replace the glass shield.
Halogen Pharmacy Lamp
No. 2508*P1
Glass Shield
Aluminum Clip
Dimm System Point 1
Replace the Fuse
An integrated fuse to protect the dimming circuit
can be found in the base of the lamp. Please
check the fuse first, in case the lamp does not
come on. A four (4) Amp replacement fuse
can be found on the Holtkoetter parts website:
http://www.holtkoetter.com/products/parts/
fuse-4amp.aspx or at your local automotive or
electronics parts store.
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.
Bulb
Note of Caution
The recommended replacement bulb for this fixture is the 100 Watt Osram Bayonet Base Halogen
bulb. Use of other brands of unknown quality may cause a risk of overheating.
Care Instructions
Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be used to spot
clean. Do not use common household cleaners on lamps or fixtures, as the lacquer on the
outside of the brass may be damaged as a result.
Enjoy your new Holtkötter lamp.
Holtkötter ® and Holtkötter Leuchten® are registered trademarks of Holtkötter. All Rights Reserved.
© Holtkötter
Loading...