CLEANING/MAINTENANCE
During Season Care:
Always unplug the heater, before moving or cleaning.
1. Carefully wipe the unit with a soft, damp cloth. Please
be very cautious near the motor and heating elements.
2. After cleaning, be sure to completely dry the unit with
a cloth or towel.
After Season Care:
1. Store heater in a cool, dry location.
2. The manufacturer recommends that you store the unit
in its original carton.
TROUBLESHOOTING
If your heater fails to operate:
1. Make sure the electrical outlet or circuit breaker is
working.
2. Check for obstructions. If you find an obstruction turn
the heater off, and follow the reset instructions in the
manual. Carefully remove the obstruction.
3. The thermostat might be set too low. Turn the
thermostat knob clockwise until the heater restarts.
Please DO NOT attempt to open or repair the heater.
Please see the Warranty for Service Instructions
or call consumer service at 1-800-546-5637.
PLEASE READ AND SAVE THESE
IMPORTANT SAFETY INSTRUCTIONS
FEATURES - OPERATIONS
Thank you for purchasing this Holmes®product. We
understand the value of quality and are committed to
making superior products that stand the test of time. We trust
this product will exceed your expectations of quality and
reliability. We hope that you enjoy this product and will
consider purchasing another Holmes®product in the future.
To see our full product line or if you have any questions or
comments about this product, please visit our website at:
www.holmesproducts.com.
When using electrical appliances, basic safety precautions
should always be followed to reduce the risk of fire,
electric shock, and injury to persons, including the
following:
1. Read all instructions before using the appliance.
2. To avoid fire or shock hazard, plug the appliance
directly into a 120V AC electrical outlet.
3. The heater is hot when in use. To avoid burns, DO NOT
let bare skin touch hot surfaces. If provided, use
handles when moving this heater. Keep combustible
materials, such as furniture, pillows, bedding, papers,
clothes, and curtains at least 3 ft (0.9 m) from the
front of the heater and keep them away from the
sides and rear.
4. DO NOT run cord under carpeting. DO NOT cover cord
with throw rugs, runners, or the like. Arrange cord
away from traffic area and where it will not be tripped
over.
5. This heater is not intended for use in bathrooms,
laundry areas and similar indoor location. NEVER
locate heater where it may fall into a bathtub or other
water container.
6. Extreme caution is necessary when any heater is used
by, or near children or invalids, and whenever the
heater is left operating and unattended.
7. Always unplug the heater when not in use.
8. When unplugging, be sure to pull by the plug and not
the cord.
9. DO NOT insert or allow foreign objects to enter any
ventilation or exhaust opening as this may cause an
electric shock or fire, or damage the heater.
10. DO NOT operate heater with a damaged cord or plug,
or after the heater malfunctions, has been dropped or
damaged in any manner. Return appliance to
manufacturer for examination, electrical or mechanical
adjustment, or repair.
11. A heater has hot and arcing or sparking parts inside.
DO NOT use it in areas where gasoline, paint, or
flammable liquids are used or stored.
12. Use appliance only for intended household use as
described in this manual. Any other use not
recommended by the manufacturer may cause fire,
electric shock, or injury to persons. The use of
attachments not recommended or sold by the
manufactuer may cause hazards.
13. DO NOT use outdoors.
14. To prevent a possible fire, DO NOT block air intakes or
exhaust in any manner. DO NOT use on soft surfaces,
like a bed, where openings may become blocked.
15. To disconnect heater, turn controls to OFF, then remove
plug from outlet.
16. Avoid the use of an extension cord because the
extension cord may overheat and cause a risk of fire.
However, if you have to use an extension cord, the
cord shall be No. 14 AWG minimum size and rated not
less than 1875 watts.
17. If the heater will not operate, see specific instructions
on Auto Safety Shut-off.
18. DO NOT attempt to repair or adjust any electrical or
mechanical functions on this unit. Doing so will void
your warranty. The inside of the unit contains no user
serviceable parts. All servicing should be performed by
qualified personnel only.
19. Discontinue use if plug or outlet is hot. It is
recommended that the outlet be replaced if plug or
outlet is hot to touch.
CLEANING/MAINTENANCE
TROUBLESHOOTING
THIS APPLIANCE HAS A POLARIZED PLUG (one blade is wider than the
other). To reduce the risk of electric shock, this plug is intended to fit in
a polarized outlet only one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit, contact a qualified
electrician to install the proper outlet.
DO NOT ATTEMPT TO MODIFY THIS PLUG OR DEFEAT THIS
SAFETY FEATURE IN ANY WAY.
PLEASE READ AND SAVE
THESE IMPORTANT SAFETY
INSTRUCTIONS
TECHNICAL SPECIFICATIONS
• Wattage: 1500W (+5% –15%)
• Working voltage: 120V AC/60Hz
AUTO SAFETY SHUT-OFF WITH TIP-OVER
PROTECTION
This heater is equipped with a Total Safety System with
tip-over protection that will shut-off the heater in an
overheat situation.
Tip-Over Shut Off:
When the unit is accidentally knocked over, it will shut off.
To reset, simply place the heater in an upright position.
Overheat Shut-Off:
When a potential overheat temperature is reached, the
system will shut the heater off and the caution light will
illuminate. Make sure heater is clear of all obstructions. It
can only resume operation when the user resets the unit.
RESET INSTRUCTIONS:
This unit is equipped with an automatic reset feature. If the
unit shuts off, wait for it to cool down (5-10 minutes).
When cool, the unit will automatically restart.
SETTING THE THERMOSTAT
1. Before setting the thermostat, allow heater to operate
and warm up the room. You need to set thermostat
clockwise on HI to start heater. (See Fig.1)
2. When the desired temperature/comfort level is
reached, lower the thermostat setting until the
fan/heater stops operating.
3. The control will now automatically maintain the preset
temperature level by turning the heater ON and OFF.
NOTE: It is normal for the heater to cycle ON and OFF as
it maintains the preset temperature. To prevent the unit
from cycling, you need to raise the thermostat setting.
PRE-OPERATING INSTRUCTIONS
1. Carefully remove your heater from the box. Please
save the carton for off-season storage.
2. Make sure the unit is in the OFF position before
plugging the heater into the outlet.
3. Avoid overloading your circuit by not using other high
wattage appliances in the same outlet. At 1500 Watts,
this unit draws 12.5 amps.
NOTE: this unit is for FLOOR USE ONLY.
OPERATING INSTRUCTIONS
1. For heater operation, please set the Thermostat
clockwise all the way to HI. (See Fig.1)
2. The Power Light will remain lit during operation.
B
C
D
A
Fig.1
A. THERMOSTAT CONTROL
(with “
o” OFF)
B. POWER LIGHT
C. CAUTION LIGHT
D. CARRY HANDLE (rear
of unit)