Holmes HAWF2020 User Manual
HAWF-2020N
TWIN
WWIIIINNNNDDDDOOOO
WW
WW FFFFAAAANNNN
WW
Owner’s Guide
☎INFO HOT-LINE: If, after reading this owner’s guide you have any questions or comments, please call 1-800-5-HOLMES
and a Customer Service Representative will be happy to assist you.
Page1
PLEASE READ AND SAVE THESE INSTRUCTIONS
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic safety precautions should always
be taken including the following:
• Use fan only for purposes described in the instruction manual.
• To protect against elec trical shock do not immerse unit, plug or cord
in water or spray with liquids.
• Close supervision is necessary when any appliance is used by or near
children.
• Unplug from outlet when not in use, when moving fan from one location to another, before putting on or taking off parts, and before cleaning.
• Avoid contact with moving parts.
• Do not operate in the presence of explosive and/or flammable fumes.
• Do not place fan or any parts near an open flame, cooking or other
heating appliance.
• Do not operate any appliance with a damaged cord, plug, after the
appliance malfunctions, or has been dropped/ damaged in any manner.
• The use of attachments not recommended or sold by the appliance
manufacturer may cause hazards.
• Do not use outdoors.
• Do not let the cord hang over the edge of a table , counter, or come in
contact with hot surfaces.
• To disconnect, grip plug and pull from wall outlet. Never yank on
cord.
• Always use on a dry, level surface.
• Do not operate without fan grills properly in place.
• This product is intended for household use ONLY and not for commercial or industrial applications.
PLEASE READ AND SAVE THESE INSTRUCTIONS
WARNING: To reduce the risk of fire or electrical shock, DO NOT
USE THIS FAN with any SOLID STATE Fan Speed Control Device
PRE-INSTALLATION INSTRUCTIONS:
Carefully unpack all contents of carton.
• The window fan comes fully assembled and is ready for immediate
installation.
• Before installation, familiarize yourself with the built-in 7”extender
on the right side of the fan, and the two additional 3.5” extenders
which attach to the left side of the fan housing (see figure #1.) The
extra extenders are packed in styrofoam at each end of the box.
WE RECOMMEND KEEPING YOUR WINDOW SCREEN IN PLACE
INSTALLATION INSTRUCTIONS:
This window fan has been designed to fit double-hung windows with minimum openings of 22” wide and 10” high.
This fan is designed and recommended for use with a screen in the window.
For DOUBLE-HUNGand SLIDER WINDOWS:
NOTE: On SLIDER WINDOWS the bottom section must be the side you add
extenders to (left side). The controls should face toward the window.
Step 1. With the window open take an accurate measurement of the open-
ing where the unit will be placed.
Step 2. Match your window measurement with the installation guide on
page 3.
Step 3. Once you have attached the extender panel(s) (if needed), set the
fan in the window. You will complete installation with built-in
extender. Pull out both clips on the right side of the fan then pull
out the built in extender. To lock extender into place, push the
clips down.
Step 4. Carefully close the window onto the top of the fan so that the bot-
tom edge of the window rests behind top line of fan housing. This
helps keep the fan in place.
For slider windows (will fit in windows 10” wide and 36” high) : In a slider
window, the control must face inward, towards
the window. The
7” built in
extender will be
positioned on
top. Prior to
installing unit in
window, measure
the height and
adjust the upper
extender for a
snug fit.
Note: In some slider windows you may need to remove the screen.
CASEMENT WINDOWS:
For a safe, secure fit in your casement window, you will need a special bracket
system. For easier installation in a casement window, we provide you with two
brackets and screws at no additional cost. Please keep in mind, your window
must to be at least 22” high and 10” wide to use this window fan/bracket combination. Please call our customer service department, 1-800-5-HOLMES, for
further assistance.
Page2 Page 3
A. TWO 3.5” SLIDE ON EXTENDERS
B. TOP WINDOW SUPPORT
C. 2 SPEED MOTOR CONTROL
D. BUILT-IN SLIDE-OUT EXTENDER (PULLS OUT 7”)
C
B
D
A
(fig. 1)
(fig. 2)
THIS PRODUCT IS EQUIPPED WITH A POLARIZED A.C.
(Alternating Current) PLUG (a plug having one
blade wider than the other). This plug will fit into
the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the
outlet, try reversing the plug. If the plug should still fail to fit, contact an
electrician to replace the obsolete outlet.
DO NOT DEFEAT THE SAFETY PURPOSE OF THIS POLARIZED PLUG
Loading...