Holmes HASF99 User Manual
Power
Stand Fan
Owner ’s Guide
HASF99
PLEASE READ AND SAVE THESE IMPORTANT INSTRUCTIONS
®
When using electrical appliances, basic safety precautions should
always be followed to reduce the risk of fire, electric shock, and
injury to persons, including the following:
1) Read all instructions before using the appliance.
2) To avoid fire or shock hazard, plug the appliance directly into a
120 V AC electrical outlet.
3) Keep the cord out of heavy traffic areas. DO NOT let the cord
hang over the edge of a table or counter. To avoid fire hazard,
NEVER put the cord under rugs, near heat registers, radiator,
stoves, or heaters.
4) To protect against electrical hazards, DO NOT immerse in water or
other liquids. Do not use near water.
5) Close supervision is necessary when any appliance is used by or
near children, or by disabled people.
6) Always unplug the fan before moving it, putting on or taking off
parts, cleaning, or whenever the fan is not is use. Be sure to pull
by the plug and not the cord.
7) Avoid contact with moving parts. DO NOT operate without fan
grills properly in place.
8) DO NOT operate any appliance with a damaged cord or plug, if
motor fan fails to rotate, after the appliance malfunctions, or if it
has been dropped or damaged in any manner. Return appliance
to manufacturer for examination, electrical or mechanical adjustment, or repair.
9) DO NOT operate in the presence of explosive and/or
flammable fumes.
10) Use appliance only for intended household use as described in this
manual. Any other use not recommended by the manufacturer
may cause fire, electric shock, or injury to persons. The use of
attachments not recommended or sold by The Holmes Group may
cause hazards.
11) DO NOT use outdoors.
12) Always use on a dry, level surface.
13) Keep unit away from heated surfaces and open flames.
14) WARNING: To reduce the risk of fire or electric shock, DO NOT use
this fan with any solid-state speed control device.
15) DO NOT attempt to repair or adjust any electrical or mechanical
functions on this unit. Doing so will void your warranty. The
inside of the unit contains no user serviceable parts. All servicing
should be performed by qualified personnel only.
PLEASE READ AND SAVE THESE
IMPORTANT SAFETY INSTRUCTIONS
THIS PRODUCT IS EQUIPPED WITH A POLARIZED AC
(Alternating Current) PLUG (a plug having one blade wider
than the other). This plug will fit into the power outlet
only one way. If the plug does not fit fully into the outlet,
reverse the plug. If it still does not fit, contact qualified
personnel to install the proper outlet.
DO NOT DEFEAT THE SAFETY PURPOSE OF THIS
POLARIZED PLUG IN ANY WAY
ASSEMBLY INSTRUCTIONS
Base / Pole Assembly
NOTE: Poles are the same size and are interchangeable
Step 1: Insert one of the poles through the base cover and twist the
pole clockwise to lock in position. Be careful to align the
cut-away grooves on the threaded joint (male end) with the two
protruding raised pieces inside the hollow end of the base cover.
Step 2: Turn the base cover upside down (with the top of the pole you
just inserted facing the floor) and place the weighted insert into
the base cover. The pole threads will be exposed as they
protrude through the insert.
NOTE: HOLD THE POLE, BASE COVER AND WEIGHTED INSERT IN ONE
HAND WHILE TIGHTENING THE BASE NUT WITH THE OTHER HAND.
I
E
F
G
H
A. Front grill
B. Rear grill
C. Speed control knobs (not shown)
D. Oscillation control knob
E. Pole (interchangable)
F. Pole (interchangable)
G. Base
H. Weight
I. Base nut
B
D
Figure 1
C
A
PLEASE READ AND SAVE
THESE IMPORTANT
SAFETY INSTRUCTIONS
Loading...