Holmes HASF1320, HASF1705 User Manual
Oscillating
Stand Fan
Owner ’s Guide
HASF1320
HASF1705
PLEASE READ AND SAVE THESE IMPORTANT INSTRUCTIONS
PLEASE READ AND SAVE
ILLUSTRATION
THESE IMPORTANT
SAFETY INSTRUCTIONS
When using electrical appliances, basic safety precautions should always
be followed to reduce the risk of fire, electric shock, and injury to
persons, including the following:
1) Read all instructions before using the appliance.
2) To avoid fire or shock hazard, plug the appliance directly into a
120V AC electrical outlet.
3) Keep the cord out of heavy traffic areas. DO NOT let the cord
hang over the edge of a table or counter. To avoid fire hazard,
NEVER put the cord under rugs, near heat registers, radiators,
stoves, or heaters.
4) To protect against electrical hazards, DO NOT immerse in water or
other liquids. Do not use near water.
5) Close supervision is necessary when any appliance is used by or
near children, or by disabled people.
6) Always unplug the fan before moving it, putting on or taking off
parts, cleaning, or whenever the fan is not is use. Be sure to pull
by the plug and not the cord.
7) Avoid contact with moving parts. DO NOT operate without fan grills
properly in place.
8) DO NOT operate any appliance with a damaged cord or plug, if
motor fan fails to rotate, after the appliance malfunctions, or if it
has been dropped or damaged in any manner. Return appliance
to manufacturer for examination, electrical or mechanical
adjustment, or repair.
9) DO NOT operate in the presence of explosive and/or
flammable fumes.
10) Use appliance only for intended household use as described in this
manual. Any other use not recommended by the manufacturer
may cause fire, electric shock, or injury to persons. The use of
attachments not recommended or sold by The Holmes Group may
cause hazards.
11) DO NOT use outdoors.
12) Always use on a dr y, level surface.
13) Keep unit away from heated surfaces and open flames.
14) WARNING: To reduce the risk of fire or electric shock, DO NOT use
this fan with any solid-state speed control device.
15) DO NOT attempt to repair or adjust any electrical or mechanical
functions on this unit. Doing so will void your warranty. The inside
of the unit contains no user serviceable parts. All servicing should
be performed by qualified personnel only.
PLEASE READ AND SAVE
THESE IMPORTANT
SAFETY INSTRUCTIONS
THIS PRODUCT IS EQUIPPED WITH A POLARIZED AC
(Alternating Current)PLUG (a plug having one blade wider
than the other). This plug will fit into the power outlet
only one way. If the plug does not fit fully into the outlet,
reverse the plug. If it still does not fit, contact qualified
personnel to install the proper outlet.
DO NOT DEFEAT THE SAFETY PURPOSE OF THIS
POLARIZED PLUG IN ANY WAY.
I
J
A
B
A. Logo Plate
B. Front Grill
C. Grill Clips
D. Blade Cap
E. Fan Blade
F. Rear Grill Mounting-Nut
G. Rear Grill
H. Motor Shaft
I. The Oscillation Control Knob
J. Motor Housing
K. Upper Pole
L. Fan Post Screw
M. Long Extension Pole
N. Short Extension Pole
O. Lower Pole
P. Base Cap
Q. Screws (4)
R. Foot Extensions (2)
D
E
C
F
R
H
G
N
K
L
M
O
ASSEMBLY INSTRUCTIONS
Base / Pole Assembly
Step 1: Unscrew the four screws on the two foot extensions.
Step 2: Attach the two foot extensions by placing the top foot over
the bottom foot. Make sure to insert the cut outs on each foot
extension into one another.
Step 3: Align the lower pole over the two foot extensions making sure
that the holes in the lower pole align with the holes in the two
foot extensions. Using the four screws, screw the lower pole
into the foot extensions until secure. Slide the base cap over
the lower pole until the cut outs on the base cap cover each
foot extension.
Step 4:
For Maximum Height:
Insert the long extension pole (M) into the lower pole making
sure to align the two dimples on the extension pole with the
keyed slot on the lower pole. Turn clockwise to lock into place.
For Minimum Height:
Insert the short extension pole (N) into the lower pole making
sure to align the two dimples on the extension pole with the
keyed slot on the lower pole. Turn clockwise to lock into place.
P
Q
Loading...