Holmes HAPF629 User Manual

CLEANING / MAINTENANCE

NOTE: Ensure that fuse cover is completely open before attempting to remove fuse.

3. Remove fuse carefully by using a small screwdriver to pry the fuse out of the compartment by the metal ends of the fuse.(see Figure 4)

4. Place plug on a solid, flat surface. Insert new 5 Amp, 125 Volt fuse into fuse compartment and use a small screwdriver to secure the metal ends of the fuse into the compartment.

CAUTION: Risk of fire. Replace fuse only with 5 Amp, 125 Volt fuse.

5. Slide fuse cover closed completely. If fuse cover is difficult to close, make sure fuse is secured in place completely by pressing down on metal ends of the fuse.

WARNING: Risk of fire. Do not replace attachment plug. Contains a safety device (fuse) that should not be

removed. Discard product if the attachment plug is damaged.

FAN CLEANING

• Always unplug the fan before cleaning.

• Do not allow water to drip on or enter into fan housing.

• Be sure to use a soft cloth moistened with a mild soap solution.

• Do not use any of the following as a cleaner: gasoline, thinner, or benzene.

Clean the fan grill, housing and base with a soft, damp cloth. DO NOT ATTEMPT TO REMOVE THE FAN BLADE. Please use caution around the motor housing area. Do not allow the motor or other electrical components to be exposed to water.

FAN STORAGE

When storing your fan in the off season, it is important to keep it in a safe dry location. It is important to protect the fan head from dust. We strongly recommend using the original box from purchase.

If you have any questions regarding your product or would like to learn more about other Holmes® products, please visit our website at www.holmesproducts.com. For inquiries regarding recycling and proper disposal of this product, please contact your local waste management facility.

Figure 4

Fuse

Fuse cover

Metal ends

WARRANTY INFORMATION

3 YEAR LIMITED WARRANTY

Sunbeam Products, Inc. or if in Canada, Newell Industries Canada ULC (collectively “Sunbeam”) warrants that for a period of three years from the date of purchase, this product will be free from defects in material and workmanship. Sunbeam at its option, will repair or replace this product or any component of the product found to be defective during the warranty period. Replacement will be made with a new or remanufactured product or component. If the product is no longer available, replacement may be made with a similar product of equal or greater value. This is your exclusive warranty. Do NOT attempt to repair or adjust any electrical or mechanical functions on this product. Doing so will void this warranty. This warranty is valid for the original retail purchaser from the date of initial retail purchase and is not transferable. Keep the original sales receipt. Proof of purchase is required to obtain warranty performance. Sunbeam dealers, service centers, or retail stores selling Sunbeam products do not have the right to alter, modify or any way change the terms and conditions of this warranty. This warranty does not cover normal wear of parts or damage resulting from any of the following: negligent use or misuse of the product, use on improper voltage or current, use contrary to the operating instructions, disassembly, repair or alteration by anyone other than Sunbeam or an authorized Sunbeam service center. Further, the warranty does not cover: Acts of God, such as fire, flood, hurricanes and tornadoes.

What are the limits on Sunbeam Liability?

Sunbeam shall not be liable for any incidental or consequential damages caused by the breach of any express, implied or statutory warranty or condition. Except to the extent prohibited by applicable law, any implied warranty or condition of merchantability or fitness for a particular purpose is limited in duration to the duration of the above warranty. Sunbeam disclaims all other warranties, conditions or representations, express, implied, statutory or otherwise. Sunbeam shall not be liable for any damages of any kind resulting from the purchase, use or misuse of, or inability to use the product including incidental, special, consequential or similar damages or loss of profits, or for any breach of contract, fundamental or otherwise, or for any claim brought against purchaser by any other party. Some provinces, states or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts, so the above limitations or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights that vary from province to province, state to state or jurisdiction to jurisdiction.

How to Obtain Warranty Service

In the U.S.A. If you have any questions regarding this warranty or would like to obtain warranty service, please visit our website at www.holmesproducts.com or direct your correspondences to ATTN: Holmes, Sunbeam Products, Inc., PO Box 3900, Peoria IL 61614. Please do not return product to this address. The PO Box listed can only receive letters or envelopes. In Canada If you have any questions regarding this warranty or would like to obtain warranty service, please visit our website at www.holmesproducts.com or direct your correspondences to ATTN: Holmes, Sunbeam Products, Inc., PO Box 3900, Peoria IL 61614. Please do not return product to this address. The PO Box listed can only receive letters or envelopes. In the U.S.A., this warranty is offered by Sunbeam located in Sunbeam Products, Inc., PO Box 3900, Peoria IL 61614. In Canada, this warranty is offered by Newell Industries Canada ULC located at 20 B Hereford Street, Brampton, Ontario L6Y 0M1. If you have any other problem or claim in connection with this product, please write our Consumer Service Department.

PLEASE DO NOT RETURN THIS PRODUCT TO ANY OF THESE ADDRESSES OR TO THE PLACE OF PURCHASE.

Owner’s Guide

HAPF629

Blizzard® Oscillating Grill

Power Fan

197370 HAPF629_18EM1 Printed In China GCDS-HOL422941-JC

HAPF629_18EM1.indd 1 10/22/18 10:58

PLEASE READ AND SAVE THESE IMPORTANT INSTRUCTIONS

PLEASE READ AND SAVE THESE

IMPORTANT SAFETY INSTRUCTIONS

FEATURES - OPERATIONS

CLEANING / MAINTENANCE

When using electrical appliances, basic safety precautions should always be taken including the following:

1. Read all instructions before using this appliance.

2. Use fan only for purposes described in the instruction manual.

3. To protect against electrical shock do not immerse unit, plug or cord in water or spray with liquids and plug the appliance directly into a 120V AC electrical outlet.

4. Close supervision is necessary when any appliance is used by or near children.

5. Unplug from outlet when not in use, when moving fan from one location to another, before putting on or taking off parts and before cleaning.

6. Avoid contact with moving parts.

7. Do not operate in the presence of explosive and/or flammable fumes.

8. To avoid fire hazard, NEVER place the cord under rugs or any parts near an open flame, cooking or other heating appliance.

9. Do not operate any appliance with a damaged cord or plug after the appliance malfunctions, or has been dropped/damaged in any manner. Discard fan or return to an authorized service facility for examination and/or repair.

10. Do not run cord under carpeting. Do not cover cord with throw rugs, runner, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.

11. The use of attachments not recommended or sold by the appliance manufacturer may cause hazards.

THIS APPLIANCE HAS A POLARIZED PLUG (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet.

DO NOT ATTEMPT TO MODIFY THIS PLUG OR DEFEAT THIS

SAFETY FEATURE IN ANY WAY.

12. Do not let the cord hang over the edge of a table, counter or come in contact with hot surfaces or leave exposed to high traffic areas.

13. Do not use outdoors.

14. To disconnect, grip plug and pull from wall outlet. Never yank on cord.

15. Always use on a dry, level surface.

16. Do not operate fan until fully assembled with all parts properly in place.

17. This product is intended for household use ONLY and not for commercial or industrial applications.

18. WARNING: To reduce the risk of electrical shock and injury to persons, do not use in window.

19. WARNING: To reduce the risk of fire or electric shock, do not use this fan with any solid-state speed control device.

20. This product employs overload protection (fuse). A blown fuse indicates an overload or short-circuit situation. If the fuse blows, unplug the product from the outlet. Replace the fuse as per the user servicing instructions (follow product marking for proper fuse rating) and check the product. If the replacement fuse blows, a short circuit may be present and the product should be discarded or returned to an authorized service facility for examination and/or repair.

PLEASE READ AND SAVE

THESE IMPORTANT

SAFETY INSTRUCTIONS

OPERATING INSTRUCTIONS

1. Set the fan on a dry, level floor.

2. Plug cord into any standard 120 volt AC outlet.

3. To turn the fan on, press the On/Off button ( ).

4. Press the Fan Speed button ( ) to select the desired speed setting:

1-Low 2-Medium 3-High 4-Turbo

5. Press the Timer button ( ) to begin the timer sequence to off setting. Continue to press until the desired time remaining is selected. The time settings cycle in durations of 2, 4, 6, 8, 10, 12, 14 hours and will be indicated by the appropriate LED illumination. To off the timer setting , press and hold 3 seconds until LED illumination go off.

6. Press the Sleep/Breeze button ( ) to randomly mimic the natural feeling of the wind.

7. Press the Oscillation button ( ) to operate the rotating front grill. When rotating, the airflow will cover a wider area and help to circulate air throughout the room.

8. To stop the fan, press the On/OFF button ( ).

Fig. 1

See Fig.2

1. Rotating Grill

2. Blade (not shown)

3. Fan Handle

Fig. 2

4. Power Button

5. Oscillation Button

6. Adjustable Timer Button

7. Speed Button

8. Breeze/Sleep Mode Button

9. Remote Control

Fig. 3

10. Remote Control Storage

Potential for Radio/Television interference

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This product has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. The product generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that the interference will not occur in a particular installation. If the product does cause harmful interference to radio or television reception, which can be determined by turning the product on or off, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the product and the receiver.

• Connect the product into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

• Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FCC STATEMENT

REMOTE CONTROL

This remote control (see Fig. 2) requires 2 AAA batteries,

1.5V. Battery Replacement: a) Remove battery cover from remote control.

b) Remove old batteries from the remote control. c) Insert two new batteries, pressing them firmly into

their slot. d) Replace the battery cover. e) For your convenience, a remote control holder is

integrated into the back of the fan housing.

NOTE:

• Replace all batteries of a set at the same time.

• Being careful not to bend or damage the contact

spring, clean the battery contacts and devices'

contacts prior to installing the batteries.

• Remove the batteries from the equipment when it is

not being used for an extended period of time.

• Remove the used batteries promptly.

• Do not mix old and new batteries. Do not mix

alkaline, standard (carbon-zinc), or rechargeable

batteries.

• Do not discard used batteries into household trash

containers. Contact your local government for

disposal or recycling practices in your area.

CLEANING/MAINTENANCE INSTRUCTIONS

Follow these instructions to correctly and safely care for your fan. Please remember:

REPLACEABLE FUSE

If your (5 Amp, 125 Volt) replaceable fuse blows, please visit our website at www.holmesproducts.com for information on how to order a new fuse. Follow the below instructions to replace the fuse on the plug.

User Servicing Instructions

1. Unplug your fan. Grasp plug and remove from the

receptacle or other outlet device. Do not unplug by

pulling on cord.

2. Open fuse cover, located on the top of the plug, by

using your thumb or a flathead screwdriver to slide

the cover down towards the prongs.

HAPF629_18EM1.indd 2 10/22/18 10:58