Holmes HANF-75 User Manual
HANF-75
Owner’s Guide
PLEASE READ AND SAVE THESE INSTRUCTIONS
COOL FANTASY
7" PERSONAL FAN
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic safety precautions should
always be taken including the following:
• Use fan only for purposes described in the instruction manual.
• To protect against electrical shock do not immerse unit, plug or
cord in water or spray with liquids.
• Close supervision is necessary when any appliance is used by
or near children.
• Unplug from outlet when not in use, when moving fan from
one location to another, before putting on or taking off parts,
and before cleaning.
• Avoid contact with moving parts.
• Do not operate in the presence of explosive and/or flammable
fumes.
• Do not place fan or any parts near an open flame, cooking or
other heating appliance.
• Do not operate any appliance with a damaged cord, plug,
after the appliance malfunctions, or has been dropped/ damaged in any manner.
• The use of attachments not recommended or sold by the appliance manufacturer may cause hazards.
• Do not use outdoors.
• Do not let the cord hang over the edge of a table, counter, or
come in contact with hot surfaces.
• To disconnect, grip plug and pull from wall outlet. Never yank
on cord.
• Always use on a dry, level surface.
• Do not operate without fan grills properly in place.
• This product is intended for household use ONLY and not for
commercial or industrial applications.
• Warning: To reduce the risk of electric shock and injury to persons, DO NOT use in window.
WARNING: To reduce the risk of fire or electrical shock, DO
NOT USE THIS FAN with any SOLID STATE Fan Speed Control
Device
PLEASE READ AND SAVE THESE INSTRUCTIONS
ASSEMBLY INSTRUCTIONS:
Carefully unpack your Holmes COOL FANTASY
FAN. Grasp the rear of the Fan-HEAD (as illustrated) with one hand, while using your other
hand to grasp the fan stand. To complete assembly,
simply insert the fan head into the stand
OPERATING INSTRUCTIONS:
Step 1: Set fan on a dry, level surface.
Step 2: Plug cord into any standard 120 volt AC outlet. Please
make sure the Selector (Speed) Control is in the Off position.
Step 3: Selector (Speed) Control is located on the back of the Fan
Motor Housing. The speed is adjusted by turning the control
knob to the desired setting, Off-High-Low.
Figure 1
THIS PRODUCT IS EQUIPPED WITH A POLARIZED
A.C. (Alternating Current) PLUG (a plug having one
blade wider than the other). This plug will fit into
the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into
the outlet, try reversing the plug. If the plug should
still fail to fit, contact an electrician to replace the obsolete outlet.
DO NOT DEFEAT THE SAFETY PURPOSE OF THIS POLARIZED PLUG
A) Fan Head
B) Motor Housing (not shown)
C) Bottom Screw
D) Fan Stand
A
C
B
D
Loading...