Hollywood Racks HR135 User Manual

Tow ‘n Go Hitch Rack

Class III Hitch Required if you tow and carry bikes at the same time. A

Model HR135 For 2” hitches only

Assembly and Use Instructions for Traveler Style Tow ‘n Go Hitch Rack

 Drive slowly when using the rack on bumpy or dirt roads.
 Check the rack bikes and straps regularly during use.
 If you have any questions or installation problems, please see your Hollywood Racks retailer or

contact Hollywood Racks at 800-747-4085.

longer hitch ball mount may be required for use of this product. (Tow N’ Go

requires 3” of space on your hitch ball mount insert tube)

Note: This product not to be used on the back of trailers!

Installation Instructions

:

2009 version

Qty Description

Caution when using this rack and NOT towing!

1 Tow ‘n Go bike rack with Tie Down

strap attached to rack

9 Rubber Bike Cradle straps

1 Allen wrench for set screws

1. Install your trailer hitch receiver tube through
the base of the rack (at the bottom of the main
beam. See Fig. 1

2. Locate the base as far forward as possible.

3. Using Allen wrench supplied, tighten the 4 set
screws on the base unit until snug.

Support Arms (Fig. 2.1)

Rotate the support arm and align the plate
holes with the tube holes per Fig. 2a. Insert pin
and close safety clasp over pin end. To return

the support arm to it’s folded position, undo the
safety clasp, then hold the arm with one hand
and remove the pin so the arm doesn’t drop
quickly). Re-insert the pin per Fig. 2b.

Fig. 1

Fig. 2a

This bike rack can also be used when not
towing, however your trailer hitch receiver tube

(or “stinger”) is most likely not to include an
anti-wobble device. An anti-wobble device
such as a threaded hitch pin is intended to
keep the rack stable during use. Hollywood
Racks strongly recommends that you either
purchase an “after market” anti wobble device
for your hitch or use some tie-down straps to
secure the rack to the vehicle to prevent any
rack movement. If you have any questions on
how to do this, please call us at 800-747-4085.

.

”in-use” position

Fig. 2b

“folded” position