Holland Bh421-464 Owner's Manual

Instruction Manual
READ THIS BOOK FIRST
L.P. NOTICE: This grill shall be connected only to a 20 lb. L.P. cylinder that is equipped with a Sherwood Valve #PV3349 AND an overfill protection device (OPD).
BH421-AG4
Epic
Epic
The
By Holland
BARBECUE INDUSTRY
ASSOCIATION MEMBER
The only Grill
not to flare up!
TM TM
©The Holland Grill Co., Inc. V2007 PN SG5-002
ANSI Z21.58b-2006/CSA 1.6b-2006
DANGER
!
IF YOU SMELL GAS:
1. SHUT OFF GAS TO APPLIANCE.
2. EXTINGUISH ANY OPEN FLAME.
3. OPEN LID.
4. IF ODOR CONTINUES, KEEP AWAY FROM THE APPLIANCE AND IMMEDIATELY CALL YOUR GAS SUPPLIER OR YOUR FIRE DEPARTMENT.
WARNING
!
1. DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE LIQUIDS OR VAPORS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE.
2. AN LP CYLINDER NOT CONNECTED FOR USE SHALL NOT BE STORED IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE.
Simply close the lid and cook by time.
It’s guaranteed not to flare-up.
Cutaway Side View
of your patented Holland Grill
No Flare-up System
Stainless Steel
Cooking Grid
Stainless steel grid cleans
easily and prevents small
foods from falling through.
Aluminim Drip Pan
Catches all the drippings and prevents them from catching fire.
Flame Deflector
Stainless Steel shield
distrubutes the heat evenly.
Cast Iron Burner
Guaranteed for life!
Vent Stacks
They provide just the right amount of ventilation to circulate the heat. Your foods cook evenly on all sides.
Thank you for purchasing a Holland Grill. This is truly a grill that you, your family and friends will use and enjoy for many years to come.
Many years of research and new technology have gone into the entire line of Holland grills, ensuring they are safe, easy to use and grill to perfection. It’s important that you are aware that the Holland Grill is unlike any other grill on the market today. By design, it allows you to grill, steam or smoke without the worry of flare-ups associated with competitive brands. Now you can relax while preparing food without the worry and nuisance of trying to control flames that will ruin your food.
Not only will you be able to enjoy time with friends and family while you grill worry-free, you’ll be able to do so for years to come. All Holland grills are made of top quality materials which give them a sturdiness that will last for years. We use only the best materials to ensure your new grill will look like new and cook like new well into the future. This grill was designed and made for trouble-free outdoor cooking.
Please read and follow all the instructions in this manual.
E-1
HOLLAND EPIC GRILL OWNERS MANUAL
Safety Information
Please read carefully.
Gas grills are used SAFELY by millions of people when following sim­ple SAFETY precautions.
The items in the fuel system are designed for operation with the Holland Grill. They must not be replaced with any other brand. (See parts list for replacement items.)
GAS BURNER: The gas burner is constructed of heavy cast iron and should not require maintenance other than inspection for insect nests inside the venturi. If you remove the burner for cleaning, it must be reinstalled exactly as removed.
AIR SHUTTER: See item 11 in lighting instructions (see figure 6 for details.)
BURNER VALVE: The burner valve is operated in only two positions. The Off position is when the handle is across (perpendicular to) the burner, which stops the flow of gas.When the valve has been set in the Off position, it is important to close the valve at the LP gas cylinder.The LP gas cylinder is the primary valve and must be closed when the grill is not in use. The On position is when the handle is in line with the burner (see figure 6 for details. See lighting instructions for more information.) The burner valve controls the heat allowed in the grill by means of a plug orifice. This device is set at the factory and must not be tampered with or replaced. Turn off LP supply at cylinder when appliance is not in use.
ONLY A FACTORY SUPPLIED VALVE SHOULD BE USED. (See the parts list for replacement items.)
LP GAS HOSE: The LP gas hose is designed for use with LP gas only. Use with any other gas is dangerous. The hose is made of a flex­ible material to make it easy to install. This material is subject to con­siderable twisting and turning during installation. It is very important that the hose be inspected for cracks, cuts, abrasions, wear and loose fittings before each use of the outdoor cooking gas appliance. The visual inspection should include leak testing the entire length of hose and fittings. (See final assembly instructions for more information.)
If the hose shows signs of damage or leakage, it must be replaced prior to the operation of the grill. Only a factory authorized replace­ment part can be used. (See the parts list for replacement items.) Failure to properly inspect or replace hose with an authorized replace­ment may result in accident or injury.
LP GAS REGULATOR: CAUTION: Use only the gas pressure regula­tor and hose supplied with this appliance. This regulator and hose is set for an outlet pressure of 11 inches
water column. Substitution of regulator and hose by any other device or any other manufacturer's regulator and hose is dangerous and could result in serious injury. (See the parts list for replacement items.)
IMPORTANT LP CYLINDER INFORMATION: Failure to follow these DANGER statements exactly may result in a fire causing death or serious injury.
The Holland Co. Inc. recommends the use of cylinder manufacturers Manchester and Worthington, Wolfdale with a 47.6 lb water capacity. Other cylinders may be acceptable for use with the appliance
The Fuel System
FOR YOUR SAFETY
• IF YOU SMELL GAS:
1. SHUT OFF GAS TO THE APPLIANCE.
2. EXTINGUISH ANY OPEN FLAME.
3. OPEN LID.
4. IF ODOR CONTINUES, IMMEDIATELY CALL YOUR GAS SUPPLIER OR FIRE DEPARTMENT.
FOR YOUR SAFETY
1. DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS AND LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE.
2. AN LP CYLINDER NOT CONNECTED FOR USE SHALL NOT BE STORED IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE.
(A) DO NOT STORE A SPARE LP-GAS CYLINDER UNDER OR NEAR
THIS APPLIANCE; (B) NEVER FILL THE CYLINDER BEYOND 80 PERCENT FULL; AND (C) IF THE INFORMATION IN “(A)” AND “(B)” IS NOT
FOLLOWED EXACTLY, A FIRE CAUSING DEATH OR SERIOUS
INJURY MAY OCCUR.
• THIS GRILL IS NOT INTENDED TO BE INSTALLED IN OR ON RECREATIONAL VEHICLES AND/OR BOATS.
• KEEP OUTDOOR COOKING GAS APPLIANCE AREA CLEAR AND FREE FROM COMBUSTIBLE MATERIALS, GASOLINE AND OTHER FLAMMABLE VAPORS AND LIQUIDS
• THIS GRILL SHALL ONLY BE CONNECTED TO AN LP CYLINDER WITH AN OVERFILL PROTECTION DEVICE (OPD).
• THE GRILL SHOULD BE LIT AND ALLOWED TO OPERATE FOR AT LEAST 30 MINUTES BEFORE USING FOR THE FIRST TIME TO ALLOW PRESERVATIVE TO BURN OFF. AFTER SMOKE STOPS COMING OUT OF STACKS, GRILL IS READY FOR YOUR USE AND ENJOYMENT.
• THIS GRILL IS NOT FOR COMMERCIAL USE
• THIS COOKING APPLIANCE IS FOR OUTDOOR USE ONLY AND SHALL NOT BE USED
IN A BUILDING, GARAGE OR ANY OTHER ENCLOSED AREA.
• EXCESSIVELY WINDY OR COLD CONDITIONS MAY AFFECT GRILL COOKING PERFORMANCE.
• CHOOSE ONLY A LEVEL LOCATION FOR GRILL OPERATION. THE HOLLAND GRILL MUST BE SITTING SECURELY ON A LEVEL SURFACE FOR PROPER OPERATION AND EVEN HEAT DISTRIBUTION.
• YOUR GRILL IS MADE FOR OUTDOOR USE ONLY
• THE VENT STACKS AND THE AIR INTAKE OPENINGS SHOULD NEVER BE BLOCKED OR CLOSED DURING GRILL OPERATION.
• MINIMUM CLEARANCE FROM SIDES AND BACK TO COMBUSTIBLE CONSTRUCTION, 18 INCHES (50CM) FROM SIDES AND 18 INCHES (50CM) FROM BACK. IT IS VERY IMPORTANT TO OBSERVE AND MAINTAIN THE PROPER CLEARANCES FROM COMBUSTIBLE CONSTRUCTION.
• DO NOT USE THIS OUTDOOR APPLIANCE UNDER OVERHEAD COMBUSTIBLE SURFACES.
• DO NOT STORE A SPARE LP GAS CYLINDER UNDER OR NEAR THIS APPLIANCE.
WARNING: FOLLOW LOCAL CODES
• THE INSTALLATION OF THIS APPLIANCE MUST CONFORM WITH EITHER THE NATIONAL FUEL GAS CODE ANSI STANDARD REFERENCED WITH THE FOLLOWING: ANSI Z223.1/ NFPA 54, NATURAL GAS AND PROPANE INSTALLATION CODE; CSA B149.1, OR PROPANE STORAGE AND HANDLING CODE, B149.2, OR THE STANDARD FOR RECREATIONAL VEHICLES, ANSI A 119.2/NFPA 1192, AND CSA Z240 RV SERIES, RECREATIONAL VEHICLE CODE, AS APPLICABLE”.
• INSTALLATION SHALL BE IN ACCORDANCE WITH CAN/CGAB149.1 NATURAL GAS AND PROPANE INSTALLATION CODE AND LOCAL CODES WHERE APPLICABLE.
E-2
provided they are compatible with the appliance retention means (see figure 9 on page E6 for retention means point of contact).
PROPANE FUEL: Warning – propane is a flammable gas. Improper han­dling may result in an explosion and/or fire and serious accident or injury. Your grill is designed to operate on Propane (LP) gas ONLY and is equipped with the proper orifice for this gas. Caution: Do not connect this grill to any gas supply except propane or natural gas. Propane gas is heavier than air and will settle in low areas. Make certain adequate venti­lation is available when using your grill and that the gas cylinder is stored outside in a well ventilated area out of the reach of children when the grill is not in use.
LP GAS CYLINDER: This grill is designed and intended to be used with an LP gas cylinder with a nominal LP gas capacity of 20 pounds. Such a cylinder is approximately 12-3/8" in diameter with an overall height of 18­1/16". The Holland Grill does not come with an LP gas cylinder. This must be purchased separately and is available at most hardware stores. The cylinder used must be constructed and marked in accordance with the specifications for LP gas cylinders of the U.S. Department of Transportation (DOT) (4BA-240) and the National Standard of Canada CAN/CSA-B339, Cylinders, Spheres, and Tubes for the transportation of dangerous goods. Only a cylinder equipped with an overfill protection device (OPD) should be used.
The LP gas cylinder shall be used only outdoors in a well ventilated space and not in a building, garage, or any other enclosed area.The LP gas cylinder is designed to be used, stored, and transported in the upright position. The Holland Grill may be stored indoors if the LP gas cylinder is removed and stored outdoors. NEVER turn the cylinder upside down or on its side. Always transport, store and use your cylinder in the upright position. Cylinders must be stored outdoors out of the reach of children and must not be stored in a building, garage or any other enclosed area.
The cylinder must be provided with a Sherwood valve, part #PV3349, which will connect with (quick connect) the QCC-1 Fitting provided on each of our LP (propane) grills. Must also have a safety relief device hav­ing a direct communication with the vapor space of the cylinder. The cylinder supply system must be mounted vertically for proper vapor with­drawal. The cylinder shall include a collar to protect the cylinder valve. The grill must be connected to the gas supply by a hose. Turn off LP supply at cylinder when appliance is not in use.
DO NOT transport a full or empty gas cylinder in a closed automobile trunk or in a closed passenger area.
Filling the gas cylinder requires removing it from the grill. The cylinder is attached to the grill by connecting the regulator assembly to the outlet portion of the gas cylinder valve. This connection is made by the QCC-1 fitting pictured in Figure 1. The large plastic nut fits on the outside of the threads and turns right, or clockwise to tighten. No tools are necessary. Hand tight is sufficient. If a good connection is not achieved, the safety valve inside will not permit the proper amount of gas to flow. When con­necting the regulator to the cylinder valve, be sure the pressure relief valve is directed away from the front and away from the grill. If the relief valve should open, the propane will be directed where it is likely to do the least harm. To disconnect regulator assembly turn large plastic nut left or
counter-clockwise. When disconnecting and connecting the gas cylinder, be careful that the regulator assembly does not strike the grill, the ground, or any other surface. If any difficulty at all is had in connecting or dis­connecting the regulator assembly to the cylinder valve, contact your local gas supplier for assistance.
When disconnected from the cylinder, a valve cap must be installed. (See figure 1.) Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install the type of dust cap on the cylin­der valve outlet that is provided with the cylinder valve. Other types of caps or plugs may result in leakage of propane. Failure to install a valve cap when the cylinder is disconnected from the fuel system is dangerous and may result in accident or injury.
When re-connecting the LP gas cylinder, be sure to tighten the fit­ting until snug. This connection, as well as all other fittings and con­nections between the cylinder and burner valve, should be inspect­ed for damage and leak tested after every filling or re-connection.
Keep any electrical supply cord and fuel supply hose away from any heated surface.
NATURAL GAS: If natural gas is used, contact your local supplier to set it up properly. The N.G. Holland Grill is set to operate at 7 inches water column pressure, using an orifice with a #48 drill size. If your grill seems too hot, first call your local gas company to deter­mine what pressure you have.
Never allow anyone to change orifice size without authorization from factory.
SPARK IGNITER: This grill is equipped with a rotary Piezo igniter system. A simple Clockwise rotation of the igniter knob produces a spark at the burner head, lighting the burner. To check that the spark igniter is working properly, leave gas supply turned OFF and observe the spark by looking through the peep hole above the con­trol panel or from below the control panel to the left side of the burn­er in the burner opening. A small blue spark should be visible at the left side of the burner head every time the igniter “fires”. A loud “hammer” like sound is produced by the mechanism when sparking.
FIGURE 1
HANDWHEEL
REGULATOR
CAP &
STRAP
COUPLING
NUT
CONNECT Clockwise
DISCONNECT,
Counter Clockwise
CYLINDER
VALV E
20 LBS
LP GAS CYLINDER
GRILL INSTALLER - LEAVE THIS INSTRUCTION BOOKLET FOR THE GRILL OWNER. GRILL OWNER - SAVE THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE.
Loading...
+ 11 hidden pages