Holis HOLNVR08, HOLNVR08xxx8P Quick Start Manual

Network Video Recorder

HOLNVR08xxx

HOLNVR08xxx8P

Quick Start Guide

8200-1104-02 B0

i

Notice

Please read this manual thoroughly and save it for future use before attempting to connect or operate
this unit.

The information in this manual was current when published. The manufacturer reserves the right to
revise and improve its products. All specifications are therefore subject to change without notice.

Copyright

Under copyright laws, the contents of this manual may not be copied, photocopied, reproduced,
translated or reduced to any electronic medium or machine-readable form, in whole or in part, without
prior written consent of Tyco Security Products. © 2015 Tyco Security Products. All rights reserved.

Customer Service

Thank you for using Tyco Security Products. We support our products through an extensive worldwide
network of dealers. The dealer through whom you originally purchased this product is your point of
contact if you need service or support. Our dealers are empowered to provide the very best in
customer service and support. Dealers should contact Tyco Security Products at [phone] or
[phone] or on the Web at www.holisnvr.com

Trademarks

The trademarks, logos, and service marks displayed on this document are registered in the United
States [or other countries]. Any misuse of the trademarks is strictly prohibited and Tyco Security
Products. will aggressively enforce its intellectual property rights to the fullest extent of the law,
including pursuit of criminal prosecution wherever necessary. All trademarks not owned by Tyco
Security Products. are the property of their respective owners, and are used with permission or allowed
under applicable laws.
Product offerings and specifications are subject to change without notice. Actual products may vary
from photos. Not all products include all features. Availability varies by region; contact your sales
representative.

Sensormatic Electronics LLC
6600 Congress Avenue
Boca Raton,
FL33487
U.S.A.

ii

Table of Contents

Important Safeguards and Warnings ......................................................................................................iii

Hardware Installation and Connection .................................................................................................... 1

Check Unpacked NVR ................................................................................................................... 1

About Front Panel and Rear Panel ................................................................................................ 1

After Remove the Chassis .............................................................................................................. 1

HDD Installation .............................................................................................................................. 1

Front Panel ..................................................................................................................................... 3

Rear Panel ...................................................................................................................................... 5

Connection Sample ................................................................................................................................. 7

GUI Operation ......................................................................................................................................... 8

Login ............................................................................................................................................... 8

Remote Device ............................................................................................................................... 9

Schedule ....................................................................................................................................... 11

Real time Playback ....................................................................................................................... 13

Preview control interface ..................................................................................................... 13

Web Operation ...................................................................................................................................... 15

Network Connection ............................................................................................................ 15

About PoE address setup, operation and allocation. ............................................................... 15

Login .................................................................................................................................... 16

Main Window ....................................................................................................................... 17

LAN Login ................................................................................................................................ 17

WAN Login ............................................................................................................................... 17

Appendix Toxic or Hazardous Materials or Elements .................................................................. 18

iii

Important Safeguards and Warnings

1．Electrical safety

All installation and operation here should conform to your local electrical safety codes.
We assume no liability or responsibility for all the fires or electrical shock caused by improper

handling or installation.

2．Transportation security

Heavy stress, violent vibration or water splash are not allowed during transportation, storage and
installation.

3．Installation

Keep upwards. Handle with care.
Do not apply power to the NVR before completing installation.
Do not place objects on the NVR
4．Qualified engineers needed
All the examination and repair work should be done by the qualified service engineers.
We are not liable for any problems caused by unauthorized modifications or attempted repair.

5．Environment

The NVR should be installed in a cool, dry place away from direct sunlight, inflammable, explosive
substances and etc.

This series product shall be transported, storage and used in the specified environments.

6. Accessories

Be sure to use all the accessories recommended by manufacturer.
Before installation, please open the package and check all the components are included.
Contact your local retailer ASAP if something is broken in your package.

7. Lithium battery

Improper battery use may result in fire, explosion, or personal injury!
When replace the battery, please make sure you are using the same model!

Before your operation please read the following instructions carefully.

Installation environment

 Keep away from extreme hot places and sources；
 Avoid direct sunlight；
 Keep away from extreme humid places；
 Avoid violent vibration；

iv

 Do not put other devices on the top of the NVR；
 Be installed in well ventilated place; do not block the vent.

Accessories
Check the accessories after opening the box：

 Please refer to the packing list in the box *

1

Hardware Installation and Connection

Note
All the installation and operations should conform to your local electric safety rules.

Check Unpacked NVR

When you receive the NVR from the forwarding agent, please check whether there is any visible damage.
The protective materials used for the package of the NVR can protect most accidental clashes during
transportation. Then you can open the box to check the accessories.

Please check the items in accordance with the list (Remote control is optional). Finally you can remove the
protective film of the NVR.

About Front Panel and Rear Panel

For detailed information of the function keys in the front panel and the ports in the rear panel, please refer to
the User Manual included in the resource CD.

The model label in the front panel is very important; please check according to your purchase order.
The label in the rear panel is very important too. Usually we need you to represent the serial number when

we provide the service after sales.

After Remove the Chassis

Please check the data cable, power cable, COM cable and main boar cable connection is secure or not.

HDD Installation

CAUTION

Please turn off the power before you replace the HDD.
The pictures listed below for reference only

You can refer to the User Manual for recommended HDD brand. Please use HDD of 7200rpm or higher.
Usually we do not recommend the PC HDD.

For detailed operation instruction, please refer to the User Manual included in the resources CD.

2

1. Use the screwdriver to loose the screws of the rear panel and then remove the front cover.

2. Put the HDD to the HDD bracket in the chassis and then line up the four screws to the four holes in
the HDD. Use the screwdriver to fix the screws firmly to secure HDD on the HDD bracket

3. Connect to the HDD data cable to the main board and the HDD port respectively. Loosen the power
cable of the chassis and connect another end of the power cable to the HDD port.

4. After connect the cable, put the front cover back to the device and then fix screws of the rear panel.

3

Name

Icon

Function

Power button

Power button, press this button for three seconds to boot up or
shut down NVR.

Shift

Shift

In textbox, click this button to switch between numeral,
English(Small/Capitalized),donation and etc.

Up/1
Down/4

、

Activate current control, modify setup, and then move up and
down.

Increase/decrease numeral.

Assistant function such as PTZ menu.

In text mode, input number 1/4 (English character G/H/I)

Left/2
Right/3

 

Shift current activated control,

When playback, click these buttons to control playback bar.
In text mode, input number 2(English character A/B/C)
/3(English character D/E/F)
.

ESC

ESC

Go to previous menu, or cancel current operation.

When playback, click it to restore real-time monitor mode.

Enter

ENTER

Confirm current operation

Go to default button

Go to menu

Record

REC

Manually stop/start recording, working with direction keys
or numeral keys to select the recording channel.

Slow play/8

Multiple slow play speeds or normal playback.
In text mode, input number 8 (English character T/U/V).

Assistant

Fn

One-window monitor mode, click this button to display assistant
function: PTZ control and image color.

Front Panel

For detailed operation instruction, please refer to the User’s Manual included in the resources CD.
The front panel is shown as in Figure .

Figure 1

Please refer to the following sheet for front panel button information.