Hoist Fitness VR-COMBO User Manual
VR-COMBO
V ROC LEG EXTENSION / LEG CURL COMBO UNIT
Note: Both Serial Number and Model Number are Required when Ordering Parts
Customer Service
(800) 548-5438
(858) 578-7676
Fax
(858) 578-9558
OWNER'S MANUAL
RECORD SERIAL NUMBER HERE
CATALOG NUMBER
1208 - 002
OWNER'S MANUAL
CONTENTS
INSTRUCTIONS .....................................................................
FRAME ASSEMBLY ..............................................................
PRE-ASSEMBLY....................................................................
DECAL PLACEMENT.............................................................
DECAL REFERENCE.............................................................
PART LIST...............................................................................
ABBREVIATIONS...................................................................
BOLT SIZING CHART............................................................
WASHER SIZING CHART......................................................
MAINTENANCE SCHEDULE.................................................
02
04
33
35
36
37
40
41
43
45
GENERAL MAINTENANCE INFORMATION........................
WEIGHT TRAINING TIPS.......................................................
EXERCISE LOG......................................................................
LIMITED WARRANTY............................................................
46
47
49
50
PAGE 01
VR-COMBO ASSEMBLY
OWNER'S MANUAL
INSTRUCTIONS
Before beginning assembly please take the time to read instructions
thoroughly. Please use the various lists in this manual to make sure that
all parts have been included in your shipment. When ordering, use part
number and description from the lists. Use only HOIST replacement parts
when servicing. Failure to do so will void your warranty and could result
in personal injury.
HOIST equipment is designed to provide the smoothest, most effective
exercise motion possible. After assembly, you should check all functions to
ensure correct operation. If you experience problems, first recheck the
assembly instructions to locate any possible errors made during assembly.
If you are unable to correct the problem, call your authorized HOIST dealer.
Be sure to have your serial number and this manual when calling. When all
parts have been accounted for, continue on.
TOOLS REQUIRED
Ratchet Wrench
1/2", 9/16" and 3/4" Sockets
Adjustable Wrench
Rubber Mallet
Tape Measure
Level
Hex Key Wrench Set
VR-COMBO ASSEMBLY
PAGE 02
OWNER'S MANUAL
***THIS PAGE WAS INTENTIONALLY LEFT BLANK***
PAGE 03
VR-COMBO ASSEMBLY
OWNER'S MANUAL
FRAME ASSEMBLY
VR-COMBO ASSEMBLY
PAGE 04
A
OWNER'S MANUAL
FRAME ASSEMBLY
A
67 5/16" 1709.80
SECTION A-A
SCALE 1 : 12
1
PAGE 05
VR-COMBO ASSEMBLY
OWNER'S MANUAL
*PROPERLY INSTALLED VIEW*
1
FRAME ASSEMBLY
30
SIDE WITH CABLE BOLT.
1
NOTE:
- WRENCH TIGHTEN HARDWARE.
- INSTALL CABLE AND PULLEYS AT THE
SAME TIME.
30
BE SURE CABLE (1) IS
POSITIONED BETWEEN
PULLEY (30) AND BOTTOM
PLATE OF PULLEY HOUSING
AS SHOWN.
72
52
52
61
16
VR-COMBO ASSEMBLY
PAGE 06
OWNER'S MANUAL
FRAME ASSEMBLY
NOTE:
- WRENCH TIGHTEN HARDWARE.
- INSTALL CABLE AND PULLEYS AT THE
SAME TIME.
16
62
55
52 30
1
PAGE 07
VR-COMBO ASSEMBLY
OWNER'S MANUAL
***THIS PAGE WAS INTENTIONALLY LEFT BLANK***
VR-COMBO ASSEMBLY
PAGE 08
OWNER'S MANUAL
FRAME ASSEMBLY
66
55
59
52
NOTE:
- HAND TIGHTEN HARDWARE.
17
64
52
55
16
52
1
52
55
66
18
52
72
PAGE 09
VR-COMBO ASSEMBLY
OWNER'S MANUAL
FRAME ASSEMBLY
NOTE:
- WRENCH TIGHTEN HARDWARE.
- INSTALL CABLE AND PULLEYS AT THE
SAME TIME.
61
30
52
18
1
52
72
*PROPERLY INSTALLED VIEW*
30
1
BE SURE CABLE (1) IS
POSITIONED BETWEEN
PULLEY (30) AND BOTTOM
PLATE OF PULLEY HOUSING
AS SHOWN.
VR-COMBO ASSEMBLY
PAGE 10
OWNER'S MANUAL
FRAME ASSEMBLY
NOTE:
- HAND TIGHTEN HARDWARE.
- SOME PARTS MAY HAVE BEEN
REMOVED FOR CLARITY.
REUSE EXSISTING HARDWARE.
*
THIS PART IS ORIGINALLY
**
INCLUDED IN V-BASE UNIT,
PLEASE DISCARD BEFORE
FRAME ASSEMBLY.
**
**
*
*
*
*
*
*
*
*
17
16
PAGE 11
YOUR V-BASE UNIT MAY BE DIFFERENT THAN THE VERSION SHOWN,
BUT THE ASSEMBLY STEPS ARE THE SAME FOR ALL BASE UNITS.
VR-COMBO ASSEMBLY
OWNER'S MANUAL
FRAME ASSEMBLY
68
53
13
NOTE:
- HAND TIGHTEN HARDWARE.
- SOME PARTS MAY HAVE BEEN
REMOVED FOR CLARITY.
43
53
73
18
VR-COMBO ASSEMBLY
PAGE 12
OWNER'S MANUAL
FRAME ASSEMBLY
1
NOTE:
- SOME PARTS MAY HAVE BEEN
REMOVED FOR CLARITY.
33
44
POSITION CABLE (1) THROUGH
QUICK RELEASE (33) IN ORDER
TO SECURE CABLE TO
SHAFT (44).
*PROPERLY INSTALLED VIEW*
33
44
PAGE 13
1
VR-COMBO ASSEMBLY
OWNER'S MANUAL
FRAME ASSEMBLY
19
NOTE:
- HAND TIGHTEN HARDWARE.
- SOME PARTS MAY HAVE BEEN
REMOVED FOR CLARITY.
73
43
68
53
13
53
VR-COMBO ASSEMBLY
PAGE 14
71
OWNER'S MANUAL
FRAME ASSEMBLY
NOTE:
- HAND TIGHTEN HARDWARE.
- SOME PARTS MAY HAVE BEEN
REMOVED FOR CLARITY.
65
42
53
20
42
72
53
73
15
PAGE 15
27
41
27
VR-COMBO ASSEMBLY
Loading...