Hohner Hoodoo Hand Owner's Manual

By

OWNERS MANUAL

Ó 2007 Hohner, Inc.

1000 Technology Park Drive

Glen Allen, VA 23059

www.hohnerusa.com

www.hoodoobyhohner.com

System Components

All Hoodoo Hand systems include:

· HH1R UHF Dual-Diversity Wireless Receiver

· HHT100 Wireless Belt-pack Transmitter

· HHD135-400 Class 2 Power Transformer (may vary by country)

· LAVHH1 Mini-Lavalier Microphone designed for Harmonica Use (T3 Connector)

· 2 Patented “Hoodoo” Ring Clips for perfect Microphone placement

· 2 “AA” Batteries

· 5 ft. ¼” to ¼” line cable (for connection to PA or Amplifier)

HH1R Wireless Receiver
Front Panel

1. Power indicator

2. Channel “A” Antenna LED Lamp – lights steadily when engaged

3. Channel “B” Antenna LED Lamp

4. “NORM” Audio Level Indicator – will light when level is nominal

5. “PEAK” Audio Level Indicator – lights when input is overloaded

- If Lit, Adjust Sensitivity on HHT100 Transmitter

6. Output Level Control – Turn clockwise to increase volume

HH1R Wireless Receiver

Rear Panel

1. XLR Balanced Output – connect to FOH PA system

2. AC Adaptor Jack (for use with included HHD135-400 power supply)

3. Mute Level

- This control is typically pre-adjusted from the factory; if you experience any interference, adjust

clockwise until “NORM” audio level light goes out; back off slightly.

4. ¼” Unbalanced Output – for connection to FOH PA or Amplifier
(recommended use – connect to the Hohner “Hoodoo Box” Class “A” Tube amp, designed
specifically for harmonica!).