Hogtunes REV 200SG Kit-RM User Manual

REV 200SG Kit-RM

REV 200SG Kit-RM

High Performance Front Speaker Kit with 200 Watt Amplifier

High Performance Front Speaker Kit with 200 Watt Amplifier

For Use on 1998-2013 Ultra ClassiCs and tri-Glides

For Use on rUshmore platForm models

installation Manual

installation Manual

Thank you for choosing the Hogtunes REV 200SG KIT-RM speaker and

amplifier kit for “Rushmore” platform bikes. Since positive word of mouth is the

best way to grow our business, we want your new system to work as well as it

was designed to. If you have any questions or concerns, we are here to help.

The installation will be done in 3 major steps.

Step 1: Changing out the front speakers

Step 2: Installation of the amplifier

Step 3: Routing the power harness

Please follow the installation instructions as provided on the following pages.

A video version of this manual is available at

www.hogtunes.com If you still need

assistance, please consider a professional

installation by your motorcycle dealer.

Hogtunes Contact Information

Email: [e-mail]

Tel: [phone]

1

362F-RM FRONT SPEAKER

INSTALLATION INSTRUCTIONS

Step #1: Remove the seat and both wires (+ and -) from the battery. Remove the

outer fairing/headlamp assembly and set aside. Refer to a service
manual if you need help with this. NOTE: Placing a towel on the front
fender can help prevent scratches or “dings” from dropped tools or
fasteners, etc. Expletives will also be kept to a minimum!

Step #2: Speaker Cabinet Removal: On the brake side speaker cabinet,

carefully remove the cable going into the power port/cigarette lighter
assembly. If your bike has the CB module (mounted “sideways” on the
clutch side cabinet) undo the antenna cable and main harness. The
CB Module will stay attached to the clutch side cabinet when removed.
Undo the speaker wire plugs going into each cabinet (pink & pink with
black stripe wires).

The speaker cabinets are vital to the fairings structure.

DO NOT operate the bike without the speaker cabinets installed!

NOTE: We STRONGLY suggest completing the speaker swap on one side and
then moving to other side! Figure 1.1 and 1.2 (below) have arrows that point
to the factory fasteners that will be removed to allow the cabinets to come
out of the bike. Although the Brake Side is shown below, fastener locations
are common for both brake and clutch side cabinets.

Figure 1.1

Side view of brake side cabinet

Figure 1.2

Back view of brake side cabinet

2