Hobbico 900, 905 User Manual

HOBBICO SERIES 900 CHARGERS
INTRODUCTION
The Hobbico Series 900 Chargers are designed to quickly and safely
charge nickel-cadmium battery packs These chargers operate wherever 110-120 AC and 12V DC voltage is available Each comes with a 5 1/2-foot AC input power cord. a 3-foot DC input power cord, and a 24-inch output charge cord with a Kyosho Style Connector (Tamiya Adapter included) A Trickle Charge Mode will begin after the quick charge cycle to safely top off the battery pack A precision 15-minute timer and powerful transformer insure a deep. long-lasting charge every time
The Hobbico Model 900 AC/DC Auto-Charger is designed with the
beginner in mind It has NO complicated or involved adjustments to make, or
difficult
procedures
to
follow.
You
just
plug
in
your NiCd battery and set the timer for 15 minutes A powerful heavy duty transformer that will pump out charge after charge without ever overheating A precision 15-minute timer Trickle Pilot Light, and of course the popular Kyosho Style Connector with Tamiya Adapter are in­cluded Best of all is the very affordable price
Perfect for fast charging 6- and 7-cell NiCd battery packs wherever you are,
the
Hobbico
Model
905
AC/DC
Multi-Charger
will fully
and
quickly
charge
battery packs in most R/C cars boats, and airplanes in 15 minutes from a standard
110-120V AC wall outlet or a 12V DC auto battery Powerful as well as convenient,
its high current output
will
insure you many
safe.
full
charges
Equipped with
a
Kyosho Style Connector and Tamiya Adapter.
Entire contents © Copyright 1990, Hobbico, Inc.
2 FEATURES
Model 900
Model 900
AC/DC Auto Charger
1. 120V AC input Power Cord (5 1/2 ft.)
2. 12V DC input Power Cord (3 ft.)
3. Kyosho Style Output Charge Cord (24 in.)
4. Black Anodized Face Plate
5. Trickle Charge Light
6. Precision 15 Minute Timer
7. 1 Amp Fuse Holder
8. Tamiya Style Adapter
Model 905
Model 905 AC/DC Multi-Charger
1. 120V AC input Power
Cord (5 1/2 ft.)
2. 12V DC input Power
Cord (3 ft.)
3. Kyosho Style Output Charge Cord (24 in.)
4. Black Anodized Face Plate
5. Charge/Discharge Switch
6. Precision 15 Minute Timer
7. 1 Amp Fuse Holder
8. Tamiya Style Adapter
9. Accurate Easy-To-Read
Ammeter
OPERATING INSTRUCTIONS
3
DISCHARGING;
Model 900
• Run the battery in your model until it slows to be sure it is discharged to the proper level.
Model 905
• Connect the Battery to the Output Connector (3)
• Move the Charge/Discharge Switch (5) to the DISCHARGE Cycle.
• Turn the Timer (6) clockwise to begin the Discharge Cycle
• Monitor the ammeter (9) closely When the current drops to 1.5 amps,
the Battery is discharged to a safe level.
QUICK CHARGING: WARNING:
NEVER LEAVE BATTERIES UNATTENDED DURING QUICK CHARGE
• Discharge the Battery Pack (see Discharging instruction above).
• Connect the Input Power, either 120V AC Cord (1) or 12V DC Cord (2)
• If you are using 12V DC, connect the red lead to the positive (+) terminal and the black lead to the negative (-)
• Connect the Battery to be charged to the Output Cord (3).
Model 905
• Move the Charge/Discharge Switch (5) to the CHARGE position.
Model 900, 905
• Set the Timer (6) to the desired amount of charge time.
• The Timer will automatically switch to Trickle Charge at the end of the quick
charge cycle The Trickle Charge Light will glow at this time The Model 900 is equipped with a Trickle Charge Light to indicate when the charger is in the trickle charge mode
• If the Battery becomes warm to the touch, this is a good indication that it is
fully charged
• You may periodically wish to let the Battery trickle charge for a few hours after
quick charging. This will equalize the cells which increases capacity and run times.
4 CARE AND MAINTENANCE
Never
leave
batteries
unattended
during quick
charge!
To
give
your
batteries
long
life
never
overcharge
them
Overcharging can cause the cells to emit a great deal of heat and may damage the battery pack
• Always let your batteries cool before charging and after discharging.
When
charging with
AC
the
chargers
face
plate
will
become
warm This is due to the heat radiated by the transformer Let the charger cool after each cycle to protect it from overheating
• When replacing the fuse, only use one of equal value (1 ampere) Using higher rated fuses may damage the charger and void the warranty
HOBBICO SERIES 900 CHARGER
FIVE-YEAR WARRANTY
HOBBICO warrants this HOBBICO SERIES 900 CHARGER to be free from defects
in materials and workmanship for a period of five (5) years from the date of purchase During that
period we
will
repair or replace at our option
any
charger
that
does not meet these
standards
You
will
be required to
provide
proof
of
purchase date
(receipt
or
invoice)
If
during
the
five
year
warranty
period the
HOBBICO
SERIES
900
CHARGER
shows defects caused by abuse misuse or accident it will be repaired or replaced at our option at a service charge not greater than 50% of the current retail list price The charger will be returned to you C 0
D
NOTE:
Under no circumstances will the buyer be entitled to consequential or incidental damages
Warranty coverage is subject to the following conditions:
1. Chargers cannot be modified in any way
2. Worn parts, due to normal use, such as wires, cords, fuses, and connectors are not covered
3. Damage resulting from reverse polarity connections of source or charging batteries is not covered
For service to your HOBBICO SERIES 900 CHARGER, either in or out of warranty,
please include a written detailed description of the problem and return address Send the unit postpaid to
Hobby Services, 1610 Interstate Drive, Champaign, IL 61821
(217)
398-0007
Loading...