Hobart Food Machines MG1532 Installation Manual
ASSEMBLY INSTRUCTIONS
Adapter — KIT NO. 873440
For Hobart PRIME™ Mixer-Grinders with 15° incline cylinder and Hollymatic model 120 Bulker.
PART NO. NAME OF PART AMT.
873440 Adapter Kit (complete) .......................................................... 1
873430 Adapter, Bulker ........................................................................ 1
873437 Long Support Rod.................................................................... 1
F-34483 Assembly Instructions ............................................................. 1
ASSEMBLY
WARNING: DISCONNECT ELECTRICAL POWER.
PAPER ROLL
1. Remove the paper roll from the
Hollymatic Model 120. Pull the pin
out of the bracket underneath the
bulker. Remove the Bulker from its
pedestal by lifting straight up.
Carefully set the Hollymatic Model
120 Bulker on its side (Fig. 1).
HOLLY BULKER
BRACKET
2. Unscrew the height adjustment
screw and remove the support rod
from the pedestal. The long rod
from the kit must be used with the
Hobart PRIME™ Mixer-Grinder.
3. Assemble the Long Support Rod
from the kit into the pedestal
base making sure the grooved
part of the Support Rod is up.
Re-tighten the height adjustment
screw so the support rod is
stable, Fig. 2.
PIN
PL-41437-1
Fig. 1
LONG SUPPORT ROD
HEIGHT ADJUSTMENT SCREW
PEDESTAL
BASE
PL-41438-1
Fig. 2
701 S. RIDGE AVENUE
TROY, OHIO 45374-0001
937 332-3000
www.hobartcorp.com
FORM 34483 (May 2000)
ASSEMBLY (continued)
4. Assemble the Hollymatic model
120 bulker to the Pedestal. To
fasten the bulker to its pedestal,
insert the pin through the hole in
the bracket. The bulker can
swivel 360°. Reassemble paper
roll (Fig. 3).
5. Assemble the bulker adapter to
the bulker input tube using the
clamp provided with the
Hollymatic Bulker, (Fig. 4).
BRACKET
PIN
SUPPORT
PAPER ROLL
PL-41439-1
Fig. 3
BULKER ADAPTER
BULKER
CLAMP
6. Assemble the Tightening Ring
shipped with the Hollymatic
Bulker to the cylinder of the
Hobart Mixer-Grinder (Fig. 5). A
second clamp (also sourced from
Hollymatic, Fig. 5) must be used
to clamp the Bulker Adapter to
the Tightening Ring.
When making the final linkup of the
Hollymatic model 120 Bulker to the
Hobart Mixer-Grinder, the height of
the Bulker may need to be adjusted.
The Bulker Adapter can be swiveled
to allow the final adjustment before
locking the clamps in place.
PL-41440-1
Fig. 4
TIGHTENING RING
CLAMP
PL-41441-1
Fig. 5
FORM 34483 (May 2000) PRINTED IN U.S.A.
– 2 –
Loading...