Hobart Food Machines HWS-4-C Installation Manual

HAND WRAP STATION

MODEL

HWS-4-C ML-44225

701 S. RIDGE AVENUE

TROY, OHIO 45374-0001

937 332-3000

www.hobartcorp.com

FORM 35541 (October 2010)

TABLE OF CONTENTS

GENERAL ............................................................................................................................................. 3

INSTALLATION ..................................................................................................................................... 4

Unpacking ........................................................................................................................................ 4

OPERATION .......................................................................................................................................... 5

HWS-4-C Film Loading and Threading (Fig. 2) ............................................................................... 5

WRAPPING PACKAGES................................................................................................................. 6

CLEANING ............................................................................................................................................ 7

MAINTENANCE .................................................................................................................................... 7

TROUBLESHOOTING .......................................................................................................................... 8

© HOBART, 2010

– 2 –

Installation, Operation, and Care of

MODEL HWS-4-C HAND WRAP STATION

SAVE THESE INSTRUCTIONS

GENERAL

The HWS-4-C is a wrapping station for use with PVC fi lms (not supplied by Hobart). A scale and printer
are installed with the unit to weigh, wrap, and label packages (Fig. 1). Included is an outlet suitable for
connecting the scale and printer. The wrap station should be connected to a properly grounded 115 V.
60 Hz. 1 Ph. dedicated circuit with capacity of 15 amps. The wrap station may be installed with printer on
either the right or left side. Printer location should be specifi ed prior to assembly of unit. The wrapping
station accommodates two rolls of PVC stretch wrap fi lm (3" diameter core) up to 20" wide.

Film is cut by a heated cut-off rod which softens the fi lm on contact. Packages are sealed with the
thermostatically controlled hot plate.

Adjustable feet provide leveling, stability, and/or minor height adjustment.

Fig. 1

– 3 –