Hobart Food Machines HWS-4 Installation Manual

I

N

S

T

R

U

HAND WRAP

STATION

C

T

I

O

N

S

HAND WRAP STATION

MODEL

HWS4 ML-44113

701 S. RIDGE AVENUE

TROY, OHIO 45374-0001

937 332-3000

www.hobartcorp.com

FORM 19499 (10-95)

– 2 –

Installation, Operation, and Care of

MODEL HWS4 HAND WRAP STATION

SAVE THESE INSTRUCTIONS

GENERAL

The HWS4 is a wrapping station for use with PVC films (not supplied by Hobart). A scale and printer
are installed with the unit to weigh, wrap, and label packages. Included is a U.L. listed outlet strip
suitable for connecting the hot plate (used to seal the wrapping film) and the scale and printer. The
outlet strip should be connected to a properly grounded 115 V. 60 Hz. 1 Ph. dedicated circuit with
capacity of 15 amps. The wrap station may be installed with printer on either the right or left side.
Printer location should be specified prior to assembly of unit. The wrapping station accommodates two
rolls of PVC stretch wrap film (3" diameter core) up to 20" wide.

Film is cut by a heated cut-off rod which melts the film on contact. Packages are sealed with the
thermostatically controlled hot plate.

Adjustable feet provide leveling, stability, and/or minor height adjustment.

INSTALLATION

Assembly and installation of the HWS4 by a qualified Hobart service technician is included with
purchase price.

UNPACKING

Immediately after unpacking the unit, check for possible shipping damage. If this unit is found to be
damaged, save the packaging material and contact the carrier within 15 days of delivery.

© HOBART CORPORATION, 1986

– 3 –