Hobart Food Machines FT950 User Manual
Item # _____________________________________
Quantity ___________________________________
C.S.I. Section 11400
FT950
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
STANDARD FEATURES
■ Low water and low energy ight-type machine
■ Water usage 72 gph @ 20 psi
■ Microprocessor controls
■ Low temperature alert
■ Energy Recovery – (will require a back
draft preventer)
■ Single point vent connection
■ 42" access doors on power wash and power
rinse chambers, 34" access doors on prewash
chamber
■ Variable speed conveyor 4-5 fpm
■ Start and stop switches at both ends
■ Doors open indicator
■ Load end ush system
■ Door interlocks
■ 3 H.P. TEFC prewash, power wash and power
rinse pump motors
■ Easy to remove wash arms
■ Easy to remove scrap trays and baskets
■ 301⁄2" wide conveyor
■ Insulated hinged doors
■ Front and rear panels
FLIGHT-TYPE DISHWASHER
MODEL
❑ FT950 – Flight-Type Dishwasher
OPTIONS AT EXTRA COST
❑ Electric Tank Heat
❑ Steam Tank Heat
❑ Booster Heater
❑ Electric
❑ Steam
❑ Eco 4.8 kw Blower Dryer
❑ Electric
❑ Steam
❑ Prewash temperature control
❑ Multiple conveyor choices
❑ Circuit breakers
❑ Other options available, consult factory
ACCESSORIES
❑ Feet
❑ Extended
❑ Flanged
❑ Water hammer arrestor/PRV.
Specications, Details and Dimensions on Inside and Back.
FT950 FLIGHT-TYPE DISHWASHER
DIRECTION OF OPERATION
❑ Right to Left
❑ Left to Right
VOLTAGE
❑ 208/60/3
❑ 240/60/3
❑ 480/60/3
❑ Other voltages available. Consult factory.
LA Research Report #M660004
F40342 – FT950 Flight-Type Dishwasher Page 1 of 12
FT950
FLIGHT-TYPE DISHWASHER
DESIGN: Fully automatic, ight-type dishwasher
machine consisting of a load section with power
recirculating prewash, an 8 foot power wash, power
rinse and nal rinse section. Included with each
machine will be exible plastic strip curtains to
control over spray.
CONSTRUCTION: Stainless steel tank and chambers
with No. 3 polish on appearance surfaces. Frame,
legs and feet to be constructed of stainless steel.
Inspection doors to be chamber width.
PUMPS: Recirculating stainless steel pumps with
stainless steel impellers. Pump housing has easy to
remove coverplate for access to impeller. All pumps
are self-draining. 150 gpm prewash, power wash/
power rinse.
MOTORS: Totally enclosed fan cooled design, with
inherent overload protection. Prewash, power wash
and power rinse motors to be 3 H.P. each, conveyor
1
⁄2 H.P. Available in electrical specications of
200-240/60/3 and 480/60/3.
CONTROLS: A stainless steel control center with
electronic digital controls mounted at eye level.
Power “On/Off” and “Start/Stop” switches integrated
into keypad. Digital display indicates door(s) open,
low temperature alert, tanks/nal rinse temperatures,
and other pertinent operating data. Additional “Start/
Stop” switches are located at each end of machine.
FLIGHT-TYPE CONVEYOR: Stainless steel side
links, tie rods and conveyor tracks. Injection molded,
resilient Duraex ight links.
VENT: Single built-in vent duct with dampers
mounted in cleanable cross duct.
RECIRCULATING PREWASH SECTION: Prewash
compartment is tted with upper and lower wash
arms. Prewash ush down for prewash tank bed.
Large removable one piece perforated stainless
steel screen sloped downward to deep stainless
steel scrap basket.
TANK HEAT: Power wash and power rinse tank
water temperatures are thermostatically controlled.
Low water protection is provided. Specify either
electric or steam heat.
FINAL RINSE: Easily removed nal rinse arms.
CONVEYOR DRIVE UNIT: Powered by a 1⁄2 H.P.
motor. Trip mechanism provided on unload section.
Jam protection is provided by load sensing switch
at drive platform. Conveyor speed adjustment of
4-5 fpm is provided in the main control box.
DRAINS: Manual, hand operated, located in each
tank.
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
No other control system allows easier
monitoring.
The controls are placed in a convenient panel that
lets operators verify proper operation and temperatures at a glance.
Digital display
indicates the unit
is on, and conrms
that the doors are
closed. Automatic
door interlocks
prevent the pump and conveyor from operating if the
doors are open. Easy-to-read digital display indicates
accurate temperatures of the 150°F wash, 160°F
power rinse, 160°F dual rinse and 180°F nal rinse —
critical for proper HACCP system record-keeping.
Stainless steel pump
is built for long life.
The stainless steel
pump housing and
impeller offer greater
durability and long life.
The pump motor is
totally enclosed and fan
cooled (TEFC) to protect
it from water spray during dishroom clean-up.
The pump is also externally mounted to the frame for
added rigidity and easy access to the clean-out port.
Scrap baskets
capture food
particles and
are easy to
clean.
The sloped
screens that
carry scraps to the
scrap baskets are
steeper, so less soil gets into the tanks. The basket
opening is larger for easy cleaning and basket handles have been designed for easy lift-out access.
Flush arm keeps
load end clean.
The load end also has a
readily removable ush arm
to rinse food scraps into the
prewash area scrap basket.
Page 2 of 12 F40342 – FT950 Flight-Type Dishwasher
FT950
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
The FT950 saves water
and energy.
The unit is designed to cut
water and energy usage,
yet provide effective
cleaning and sanitizing that
meet NSF International
requirements.
This is achieved through a
carefully balanced ratio of
water ow to pressure.
At 150 gallons per minute
(gpm), the machine offers excellent wetting and
ooding over ware. Insulated doors also reduce heat
loss. The unit’s 1.25 gpm/72 gallons per hour rinse
ow rate (the lowest in the industry on a standard
machine) saves both water and the energy to heat it.
Wider, variable speed conveyor offers
increased throughput.
The conveyor on the FT950 is wider so it can handle
more ware. Result: more volume and versatility,
quicker work. Its
speed is servicer
adjustable for the
type of ware, soiled
condition, or workforce requirements.
It can be adjusted
from 4 to 5 feet per
minute.
FLIGHT-TYPE DISHWASHER
Installation is quick and easy with modular
design, minimal wiring connections, and
single point vent.
Modular design means the FT950 installs quickly,
and reliably. Sections t through 42" doors. The
control panel is already in place, premounted to the
power wash/power rinse/nal rinse section.
Wiring connections
are minimal, and there
is only a single vent
connection, saving
time and expense.
The control box uses a
“single plane” circuitry
design for easy accessibility during installation and
service. The FT950 is ready to run quickly.
BLOWER DRYER
To assist and promote drying of tableware and trays
by forced circulation of high velocity heated air
through the clean dishware section of the Hobart
Flight-Type dishmachines.
Blower dryer is built on a minimum 7' unloading
section only. Hooded chamber/blower section covers
66" length of conveyor, to provide adequate drying
time.
BLOWER: Industrial fan-type with squirrel-cage type
wheel. Housing of welded construction throughout.
Standard Energy
Recovery system.
The standard Energy
Recovery system
captures escaping
heat and steam from
the exhaust air and uses a heat exchanger to recycle
it into energy. This free energy is used to preheat the
incoming water supply before it enters the booster
heater. The cold ground temperature water passes
through a heat exchanger positioned directly in line
with the machine’s exhaust system to capture the
energy from the exhaust air to elevate the temperature of the water to 128° before it enters the booster
heater.
Blower is directly driven by a 2 H.P. motor with
sealed ball bearings. Motor construction is of open
drip proof design. The blower dryer is totally enclosed
by removable stainless steel panels mounted on top
of the dryer chamber. Exhaust requirement is 1000
C.F.M. (at standard air conditions). Sound level at
end of 7-foot unloading section, with full machine
operation is less than 85 DBA, dened by A.N.S.I.
(American National Standards Institute) Standard No.
S1.1-1960 ... below existing O.S.H.A. rules. At loading end of dishwasher, sound level is 80 DBA or less.
The blower motor is provided with inherent overload protection and a manual reset. Furnished only
in three-phase electrical specications of the basic
Flight-Type Model in 208-240/60/3 and 480/60/3.
Self-draining pumps help keep water clean.
Pumps are self-draining when the machine is shut
down, so there is no residual water left in the pumps.
F40342 – FT950 Flight-Type Dishwasher Page 3 of 12
FT950
ELECTRIC L-R
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
Page 4 of 12 F40342 – FT950 Flight-Type Dishwasher
Loading...