HM Electronics COM900CC COMMUNICATOR Operating Instructions Manual

COM900CC

OPERATING INSTRUCTIONS

The COM900CC COMMUNICATOR® is a 900MHz
receiver/transmitter designed to be used with the
HME Wireless Drive-Thru Audio System 900.
The Communicator is worn around the user’s
collar, and a lightweight headset plugs into a
connector on the unit. Its simple, pushbutton
operation with voice cues make the COM900CC
especially user friendly.

These instructions provide detailed information for
proper use of the COM900CC. Setup information
for the audio system installer is in Appendix A.

COMMUNICATOR

Figure 1. COM900CC COMMUNICATOR

®®

®

I. COM900CC CONTROLS AND CONNECTORS

A. Controls

HM ELECTRONICS, INC. 14110 Stowe Drive, Poway, CA 92064 USA ! Phone: [phone] Fax: [phone]

Figure 2. COM900CC control buttons

HME# 400423

Rev A 11/15/02

B. Connectors

Plug the headset cable connector into the cable connector on the COM900CC
collar unit, as shown in Figure 3. Be careful to correctly match the positions of the
pins inside the connector.

Figure 3. Cable connectors showing matching pin positions

II. WEARING THE COM900CC COMMUNICATOR

! Place the Communicator collar unit around your neck and put the headset on your

head as shown in Figure 4.

! Fasten the clothing clips to your collar as shown in Figure 4.
! Adjust the headset band so it rests comfortably on top of your head, with the micro-

phone to the side of your mouth.

®®

Figure 4. Correct wearing of the COM900CC

2