HMC Electronics 1500QT User Manual

1 Copyright 2009 Techspray.
For Commercial Use Only
ECO-SHOWER™ Heavy-Duty Cleaner & Degreaser
1500
Introduction
Powerful degreaser in the tradition of Techspray’s Blue Shower® cleaners. Innovative formula uses naturally-based ingredients like citrus and soy oils to soak in and quickly cut through oil and grease.
Use full strength for heavy grease or dilute with water for general cleaning (see below for dilution instructions). Ideal for cleaning tools, parts, shop equipment, motors, and industrial working surfaces. Leaves high-gloss finish, so ideal for stainless steel.
Convenient pre-saturated wipes available in a pop-up dispenser. Wipe material is low linting with patented dual-texture that has scrubbing surface on one side, wiping surface on the other.
One quart (with a trigger sprayer) and one gallon containers are ideal for surface and tool cleaning. Packaging is selected to be easily recyclable. Quart labels made of recycled paper, and cartons made of 40% recycled material. Trigger pump on quart eliminates the need for propellants, which can have a global warming impact.
Eco-ShowerTM Cleaner is fully compliant with CARB (California Air Resource Board) requirements. Also compliant with European REACH (Registration, Evaluation, Authorization & Restriction of
Chemicals) and WEEE (Waste Electrical and Electronic Equipment Directive) initiatives. It does not contain RoHS (Restriction of Hazardous Substances) restricted substances, SVHC (Substances of Very High Concern) list substances, or halides.
Features / Benefits
Clean heavy oil & grease
Concentrated and dilutable
Non-flammable
Non-corrosive, moderate pH
Safe on most plastics and painted surfaces
Biodegradable
Low VOC, zero GWP
Non-ozone depleting
Specifications
Daimler / Mercedes Benz – MSC# 3104 (1500 bulk)
Product Information
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
http://www.hmcelectronics.com
(800) 482-4440
2 Copyright 2009 Techspray.
For Commercial Use Only
Applications
Removal of heavy greases and oils
Cleaning on and around heavy machinery
Cleaning shelves and other surfaces
Application
Suggestions
Heavy degreasing Leave on 30-60 sec Light degreasing 2:1 to 10:1 Batch degreasing Can be used in ultrasonic tank full strength or
diluted, depending on soil Power washer 10:1 to 30:1 Concrete spot cleaning Hose off after 15 min Adhesive cleaning Leave on 30-60 sec Stainless steel cleaning (polished) Wipe until dry Carpet/upholstery spot remover 1:1 to 3:1 to avoid foaming
e.g. oil, paint Telecomm cable lube “ickypic” Use full strength Adhesive cleaning (dry) Let soak
Dilution Instructions
Full strength – Caked-on grease (e.g. compressors, engines, etc.), grills*, oil stains*
10 parts water : 1 part Eco-Shower – Greasy tools, floor (e.g. concrete) stains*, vents,
heavily stained (food) appliances*, scuff marks on doors, heavy grease on wheels
30-50 parts water : 1 part Eco-Shower – Chrome fittings, stainless steel, very light general cleaning
* If on food processing equipment or walking surfaces, must be washed/mopped thoroughly to
avoid slippery surface and undesirable residues.
About TECHSPRAY RENEW
TM
TECHSPRAY RENEWTM is a brand that represents High Performance Eco-CleaningTM.
Techspray
®
has applied our expertise in solvent cleaning to formulate some of the most effective eco-friendly cleaners on the market. Performance is our top priority, using the best “green” solutions as they become available. We all are at the cusp of the ongoing movement toward sustainable products, packaging, and processes. It is Techspray’s intention to stay at the cutting­edge while keeping our products powerful and cost effective.
Directions
Spray and saturate the soiled area. Let soak for 30-60 seconds depending on thickness of the
grease.
Using a lint-free wipe (we recommend Techspray 2364-50 or 2365-300 wipes), wipe lightly at
first to allow cleaning agent to break down residues.
Continue to wipe in a circular motion until the grease or oil is fully removed.
For thick greases, reapplication may be needed.
On walking surfaces, mop thoroughly after cleaning.
Material is easily rinsed by wiping with water dampened cloth.
Dispose of soiled wipe as appropriate depending on the type of material removed.
Chemical Components
Component CAS#
Alcohols,C10-14, ethoxylated .......................................................................... 66455-15-0
d-Limonene...................................................................................................... 5989-27-5
Alkyl C16-C18 Methyl Esters ........................................................................... 67784-80-9
Includes other hazardous components in non-reportable quantities.
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
http://www.hmcelectronics.com
(800) 482-4440
3 Copyright 2009 Techspray.
For Commercial Use Only
Chemical Properties (MSDS available on request)
EXPOSURE LIMIT: Limits on components not established.
Manufacturer’s recommendation 1000 ppm.
PHYSICAL STATE: Liquid
ODOR: Citrus odor
APPEARANCE: Clear, mobile liquid
pH: 6-7
PERCENT VOLATILE: 99% at 104°C
VAPOR PRESSURE: < 0.014 mmHg@20°C (VOC Composite Vapor Pressure)
BOILING POINT : 203°F (95°C)
FLASHPOINT AND METHOD (TAG Closed Cup): None to boiling point
SOLUBILITY IN WATER: Dispersible
DENSITY: ~1.00 at 25°C
VOC (by wt): 3.24%, 32.4 g/l
Performance
Tested according to modified MIL-PRF-29608 4.59 standards: Soil is applied to cleaning coupons, sprayed with cleaning fluid, allowed to sit 10-seconds, then a poly-cellulose wipe (saturated with same cleaning fluid) is dragged across one time using a dowel to maintain consistent pressure. Percentage refers to the amount of soil (by weight) removed from stainless steel test coupon.
* Composition of lube/soil blend: 2 parts Mystik #2, 2 parts Lubriplate #1242, 2 parts Slick 50 #1, 1 part Lubriplate
80W-140, 1 part Silicone TBF9-350, 1 part soil.
SAMPLE ID SOIL
CLEANING
EFFICIENCY
1500 Eco-Shower
Lube/Soil Blend*
94%
Simple Green
Lube/Soil Blend*
89%
Hydroforce
Lube/Soil Blend*
90%
Control dry wipe
Lube/Soil Blend*
29%
Control H2O wet wipe
Lube/Soil Blend*
42%
SAMPLE ID SOIL
CLEANING
EFFICIENCY
1500 Eco-Shower
Mystik #2
90%
Simple Green
Mystik #2
79%
Hydroforce
Mystik #2
79%
Control dry wipe
Mystik #2
17%
Control H2O wet wipe
Mystik #2
16%
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
http://www.hmcelectronics.com
(800) 482-4440
4 Copyright 2009 Techspray.
For Commercial Use Only
Compatibility
Metals
Test method: 15 minute immersion at room temperature in sealed jar, remove, wipe dry, and make observations. Observations made immediately after removal and drying, and 1 hour later.
Material
Compatibility
Brassfoil
Excellent
Copperfoil
Excellent
Nickel200
Excellent
Aluminum6061
Excellent
Aluminum2024
Excellent
Anodizedaluminum
Excellent
StainlessSteel316
Excellent
StainlessSteel304
Excellent
Mildcarbonsteel
Excellent
GalvanizedSteel
Excellent
Note: Eco-Shower™ is a water-based formula, so will encourage oxidation with prolonged exposure to iron, steel, and other susceptible metals.
Plastics
Test method: Tested as bulk unstressed coupons, and the following immersion times for the base chemistry: 1 minute, 5 minutes, and 15 minutes.
Material Compatibility
Material Compatibility
ABS
Excellent
PMMA
Good (1)
Nylon
Excellent
POM
Excellent
Lexan
Excellent
PP
Excellent
HDPE
Excellent
PS
Good (1)
LDPE
Excellent
PTFE
Excellent
C. E. Phenolic
Excellent
PVC
Excellent
1 = Slight softening after 15 minutes of exposure.
Environmental Policy
Techspray® is committed to developing products to ensure a safer and cleaner environment. We will continue to meet and sustain the regulations of all federal, state and local government agencies.
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
http://www.hmcelectronics.com
(800) 482-4440
5 Copyright 2009 Techspray.
For Commercial Use Only
Packaging and Availability
Eco-ShowerTM Cleaner available in the following sizes:
1500-72DSP 72 count pre-saturated wipes, 6" x 10.5" (15cm x 26.7cm) 1500-100PK 100 count individually wrapped pre-saturated wipes, 8” x 12.25” (20.3cm x 31.1cm) 1500-QT 1 quart (0.95L) w/ trigger sprayer 1500-G 1 gallon (3.8L)
Available as special order, call for pricing: 1500-5G 5 gallon (19L) 1500-54G 54 gallon (205L) 1500-275G 275 gallon (1,045L)
Resources
Techspray® products are supported by global sales, technical and customer services resources. For additional technical information on this product or other Techspray® products in the United
States, call the technical sales department at 800-858-4043, email tsales@techspray.com or visit our web site at: www.techspray.com.
North America Europe Countries Outside US
Techspray ITW Contamination Control Call to locate a distributor P.O. Box 949 Skejby Nordlandsvej 307 in your country. Amarillo, TX 79105 DK-8200 Aarhus N 800-858-4043 +45 87 400 220 email: tsales@techspray.com email: info@itw-cc.com
Important Notice to Purchaser/User: The information in this publication is based on tests that we believe are reliable. The results may vary due to differences in tests type and conditions. We recommend that each user evaluate the product to determine its suitability for the intended application. Conditions of use are outside our control and vary widely. Techspray’s only obligation and your only solution is replacement of product that is shown to be defective when you receive it. In no case will Techspray
®
be liable for any special, incidental, or consequential damages based on breach of warranty,
negligence or any other theory. Techspray
®
and Blue Shower® are registered trademarks of Techspray. Techspray RenewTM, Eco-ShowerTM, and “High
Performance Eco-Cleaning
TM
” are trademarks of Techspray.
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
http://www.hmcelectronics.com
(800) 482-4440
Loading...