Installer
Address
Tel: Fax:
After Hours:
Date:
WARNING
While this system has been designed to the highest standards it does not offer guaranteed protection against burglary or fire. Any alarm system is subject to
compromise or failure to activate for a variety of reasons. Therefore, good installation practices and regular maintenance are essential to ensure continuous
satisfactory operation of the system. The transmission of text messages is dependent on the SMS service provider. HKC Ltd. cannot guarantee successful messaging.
Messages which remain undelivered when the validity period expires are discarded. The validity period is the time the message is submitted plus 12 hours.
COPYRIGHT
Ó HKC Ltd. All Rights reserved. No part of this publication may be reproduced, transmitted, stored in a retrieval system or translated in another language in any
form or by any means - electronic, mechanical or otherwise without the prior written permission of HKC Ltd.
DISCLAIMER
HKC Ltd. makes no representations or warranties with respect to the contents hereof and specifically disclaim any implied warranties of merchantability or fitness
for any particular purpose. Further, HKC Ltd. reserve the right to revise this publication and to make changes from time to time in the contents hereof without
obligation of HKC Ltd. to notify any person of such revision.
This marking certifies that this product has been tested in a representative system complying with the requirements laid down in Electromagnetic
Compatibility directive 89/336/EEC and Low Voltage Directive 72/23/EEC and subsequent modifications.
L
td
.
SecureWatch 8/12 12/12 (1.0) User Manual Rev1.0 Issue A. 22nd of September 2004
FULL SET With Exit TimerFULL SET With Exit Timer
Press
Press
* EN 50131 requirement only
Buzzer sounds for length of exit time
Keypad displays exit time remaining
Time To Leave 30
FULL SET Without Exit TimerFULL SET Without Exit Timer
followed by User Code
OR if allowed...
* User Code
SYSTEM
ARMING
Time To Leave 29 Time To Leave 0
Press
* EN 50131 requirement only
Keypad displays....
System Arming
* User Code
SYSTEM
ARMING