HKC GSM-Q User Manual
ARM APart sets system A ARM BPart sets system B
SET ASame as ARM A (if you prefer to use the word “set”)
SET BSame as ARM B (if you prefer to use the word “set”)
FORCEThis forces the panel into the Set mode and inhibits any open
zones, tampers or faults
FORCE AThis forces the panel into the Part-Set A mode and inhibits
any open zones, tampers or faults
FORCE BThis forces the panel into the Part-Set B mode and inhibits
any open zones, tampers or faults
Note: Ask your installer if you are permitted to inhibit zones, tampers and faults
Alternatively you can inhibit zones and tampers with the following commands...
SET **Inhibits all open zones before setting the system
SET ##Inhibits all open tampers before setting the system
SET *3Inhibits a specific zone (in this example zone 3)
SET *z3This command is the same as set *3 above
SET *z03This command is the same as set *3 above
SET *z003This command is the same as set *3 above
SET #3Inhibits a specific tamper circuit (in this example tamper 3)
SET #z3This command is the same as set #3 above
SET #z03This command is the same as set #3 above
SET #z003This command is the same as set #3 above
SET *p80Inhibits a specific point-zone (in this example point 80)
SET #p80Inhibit a specific point-tamper (in this example pointer 80)
Other commands
Note: There is a one hour security lockout after seven wrong
text commands and/or user codes
!
Text your User Code followed by a space and the word ARM to your
system.
Text your User Code followed by a space and the word UNSET to
your system.
Text your User Code followed by a space, then the word LOG
followed by another space and the number of log events (between 1
and 21) to your system.
Depending on the status of your system
you will receive one of the following
confirmation messages;
Confirmed System Armed or
System Already Armed or
System Not Ready to Arm
Depending on the status of your system
you will receive one of the following
confirmation messages;
Confirmed System Unset or
System Already Unset
Depending on how many log events
you request this command might
involve several text messages from the
system to your phone
Notes:
1) If you prefer, the word SET can be used instead of ARM
2) Part arm your system by texting User Code followed by ARM A or ARM B
2222 is being used as a User code for illustrative purposes only
2222 is being used as a User code for illustrative purposes only
Note: 2222 LOG will send the last 7 log events.
Arming your system
Unsetting your system
3)When sending commands, we strongly recommend that you turn off the
predictive text feature on your phone.
Requesting the log of recent events
Note: If you prefer, the word DISARM can be used instead of UNSET
ABC
ABC
Text your User Code followed by a space and the word STATUS to
your system.
Depending on the status of your system
you will receive the following types of
messages;
System Armed / Unset
GSM Signal 80% etc.
Note: If you prefer, the word STAT can be used instead of STATUS
Getting the current status of your system
Get the list of commands sent to your phone
ABC
Text your User Code followed by a space and the word HELP to
your system.
2222 HELP
You will receive a list of the commands;
Code ARM/UNSET/FORCE
Code STATUS
Code LOG
ABC
2222 ARM
ABC
2222 UNSET
2222 LOG 2
2222 STATUS
Loading...