
Signal Generator
24MHz-1.7GHz F connector with Wi-Fi 802.11n features
Battery included
Manual mode for simple setting
APP for Smartphone/Pad usage
KEY FEATURES
CSN-01
• Output frequency range 24MHz~1.7GHz
• Stepping : 1MHz
• Output power : 40dBmv, 60dBmv
Tolerance: +/-3dBmv
• Power: USB2.0 (+5V/2A)
• Interface : USB2.0, F-type male 75Ω connector
• Wi-Fi 11b/g/n with internal antennas
• 2T2R 2.4GHz with 150Mbps PHY rate
• Frequency range : 2412~2462MHz
• Includes a 5V battery
• Simple buttons setting for Hi/Lo frequency/power
• LEDs indicator for Signal output
APP by Wi-Fi CONNECTION
The APP designed for smartphone for related parameter setting by WiFi connection.
- Android platform
- Same as CGN-DP3
Item Include
1. 24MHz~1.7GHz signal generator x 1
2. USB type A to type A cable
3. 5V/2A USB adapter
Hitron HQ - www.hitrontech.com
No. 1-8, Lihsin 1st Rd, Hsinchu Science Park
Hsinchu, Taiwan
Tel: +886 3 5786658
USA - www.hitron-americas.com
9000 E Nichols Ave
Centennial CO 80112 Suite 103
Tel: +1 303 792 3380
Europe - www.hitron-europe.com
Kingsfordweg 151 1043 GR
Amsterdam, The Netherlands
Tel: +31 20 491 9995

SPECIFICATIONS
CSN-01
Connectivity
• 1 x RF F-type male 75Ω connector
• 1 x female to female adapter
• 1 x RJ-45 Ethernet port 10/100 Mbps (Auto-
MDI/MDIX)
• 1 x USB2.0 connector
• 1 x Factory reset button
• 1 x Force power off button
Management
• App-based GUI for configuration and management
Wireless
• 802.11 b/g/n
• 2T2R 2.4GHz (2412MHz-2462MHz) 802.11n with
150Mbps PHY data rate
• 20/40MHz channel bandwidth
• Wi-Fi output power Range :
• 2.4G (.11n) 13dBm
• 2.4G (.11g) 15dBm
• 2.4G (.11b) 17dBm
Environmental
• Operating temperature: 0°C (32°F) - 40°C (104°F)
• Operating humidity: 10% - 90% (non-condensing)
• Storage temperature: -40°C (-40°F) - 80°C (176°F)
Compliance Certificates
• FCC, UL
• RoHS compliant
• IP20
Mechanical
• 9 Status LEDs
• 4 Buttons
• Dimensions: 220.3mm (L) x 92mm (W) x 42mm (H)
• Weight: 400g ± 10g
Electrical
• USB Power input: 5V / 2A
• Power consumption: 5 W (typical), 6W (max.)
• Battery with lithium battery cells
• Surge protection: RF input sustains at least 4KV,
Ethernet RJ-45 sustains at least 4KV
CSN-01_2017_1A - Issued Oct. 2017
Specifications subject to change without further notice
Trademarks owned by Hitron Technologies Inc. 2016 © Hitron Technologies Inc. – All rights reserved

Federal Communication Commission Interference
•
• This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
•
• This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by one of
the following measures:
•
• - Reorient or relocate the receiving antenna.
• - Increase the separation between the equipment and
receiver.
• - Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• - Consult the dealer or an experienced radio/TV
technician for help.
• FCC Caution: Any changes or modifications not expressly
approved by the party responsible for compliance could
void the user's authority to operate this equipment.
• This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
•
Radiation Exposure Statement:
• This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
equipment should be installed and operated with
minimum distance 20 cm between the radiator & your
body.
Statement
• Industry Canada statement:
• This device complies with ISED’s licence-exempt RSSs.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
• Le présent appareil est conforme aux CNR d’ ISED applicables
aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes : (1) le dispositif ne doit
pas produire de brouillage préjudiciable, et (2) ce dispositif doit
accepter tout brouillage reçu, y compris un brouillage
susceptible de provoquer un fonctionnement indésirable.
• Caution :
• (iii) where applicable, antenna type(s), antenna models(s), and
worst-case tilt angle(s) necessary to remain compliant with the
e.i.r.p. elevation mask requirement set forth in section 6.2.2.3
shall be clearly indicated.
• Avertissement:
• (iii) lorsqu’il y a lieu, les types d’antennes (s’il y en a plusieurs),
les numéros de modèle de l’antenne et les pires angles
d’inclinaison nécessaires pour rester conforme à l’exigence de
la p.i.r.e. applicable au masque d’élévation, énoncée à la
section 6.2.2.3, doivent être clairement indiqués.
• Radiation Exposure Statement:
• This equipment complies with ISED radiation exposure
limits set forth for an uncontrolled environment. This equipment
should be installed and operated with greater than 20 cm between
the radiator & your body.
• Déclaration d'exposition aux radiations:
Cet équipement est conforme aux limites d'exposition aux
rayonnements ISED établies pour un environnement non contrôlé.
Cet équipement doit être installé et utilisé à plus de 30 cm entre le
radiateur et votre corps.
Specifications subject to change without further notice
Trademarks owned by Hitron Technologies Inc. 2016 © Hitron Technologies Inc. – All rights reserved