Hitron CODA-4782, CODA-4582, CODA-4682 User Manual
QUICK START GUIDE
Check the Box Contents
HITRON
CODA-4582/ 4682/ 4782
Connect to the network
Set up your wireless network
Connect to a Cable Outlet
Read me
first!
STEP
Look in the box and make sure you have the following:
1
CODA-4582/4682/ 4782
The Hitron CODA-4582/ 4682/ 4782 is an application gateway that provides
wired and wireless high-speed Internet access as well as optional MoCA
(Multimedia over Coax Alliance) netwo rking to the Ethernet-enabled
devices in your home for a fast and easy home entertainment network.
Connect to a P ower Outlet
POWER CORD
ETHERNET CABLE
QUICK ST AR T GUIDE
STEP
Use a coaxial cable (not included) to connect the device’s CABLE
connector to a cable outlet.
2
Connect to an Ethernet-Equipped Device (Optional)
STEP
Use the power cord provided to connect the POWER port to a power
outlet.
3
User Configuration (Optional)
STEP
Use the Ethernet cable provided to connect one of the LAN ports
to an Ethernet-equipped device.
4
Connect with Wireless Devices (Optional)
STEP
In a web browser, enter 192.168.0.1 in the address bar followed by
Username and Password, as below.
5
Setup Complete
cusadmin
password
STEP
6
Connect your wireless devices with the WiFi
Protected Setup (WPS). Access the configuration
interface (see step 5), enter the Wireless page
to enable WPS and set Encrypt Mode to AES,
then press Save Changes.
Press this button to begin the WPS Push-Button
Configuration (PBC) procedure. Press the PBC
button on your wireless clients in the coverage
area within two minutes to enable them to join
the wireless network.
Connect your wireless devices with the correct SSID and Passphrase.
If you have not changed them, the default values are indicated on
the sticker on the back of the unit.
STEP
7
IP Addresses
If the CODA-4582 is successfully connected to the network (see LED Display)
but you cannot access the Internet from a connected computer, your
computer’s IP Address may be set up improperly. In your computer’s
network settings, ensure that it is configured to either receive an IP
address automatically (recommended) or that it has a static IP address in
the 192.168.0.10~192.168.0.254 range. For more information, consult your
operating system’s Help documentation.
Congratulations! You have successfully set up your CODA-4582/
4682/ 4782.
If you have any problems, see the section below for help in
identifying the cause.
LED Display
Power
Downsteam
Connec
t power
Upsteam
Online
Green-Steady
Off
Green-Blinking
Green-Steady
Blue-Steady
Cyan-Steady
Off
Green-Blinking
Green-Steady
Blue-Steady
Cyan-Steady
Off
Green-Blinking
Green-Steady
Device is running with AC power.
Not powered.
The modem is searching for the downstream
frequency.
Downstream frequency is locked. (1 channel only)
Downstream frequency is locked. (channel bonding)
DOCSIS 3.1 OFDM
Not scanning
The modem is searching for the upstream
frequency.
Upstream frequency is locked. (1 channel only)
Upstream frequency is locked. (channel bonding)
DOCSIS 3.1
Not scanning
Registration is in progress with cable company’s
head-end.
Gateway is operational for data transmission.
Wireless
(2.4GHz)
Wireless
(5GHz)
MoCA
(Optional)
Green-Blinking
Green-Steady
Off
Green-Blinking
Green-Steady
Off
Green-Blinking
Green-Steady
Off
The 2.4GHz wireless network is enabled, and data
is being transmitted or received.
The 2.4GHz wireless network is enabled, and no
data is being transmitted or received.
The 2.4GHz wireless network is not enabled.
The 5GHz wireless network is enabled, and data is
being transmitted or received.
The 5GHz wireless network is enabled, and no
data is being transmitted or received.
The 5GHz wireless network is not enabled.
Gateway is searching for MoCA device.
MoCA device has been detected, and the
CODA-4582/ 4682/ 4782 has successfully made a
connection.
MoCA function is not enabled.
Off
Green-Blinking
Off
Ethernet
Gateway is offline.
Ethernet is activated.
Ethernet is disabled.
USB
Green-Blinking
Off
USB device is plug-in USB port.
No USB device.
Safety Warnings
WARNING
Risk of electrical shock. Do not expose the device to water or moisture.
The device is a high-performance communications device designed for home and office environments. Do not use the device outdoors. Keep the device in an environment between 0°C ~ 40°C (32°F ~104°F). To avoid overheating, do NOT place any
object on top of the device. Do not restrict the flow of air around the cable modem. The manufacturer assumes no liabilities for damage caused by any improper use of the device.
DISCLAIMER
The manufacturer assumes no liabilities with respect to the contents of this document. The manufacturer also reserves the right to revise this document or update the content thereof without any obligation to notify any person of such revisions or
amendments. Specifications subject to change without notice.
CAUTION
The cable distribution system should be grounded (earthed) in a accordance with ANS/NFPA 70, the National Electrical Code (NEC), in particular Section 820.93, Grounding of Outer Conductive Shield of a Coaxial Cable.
FCC Statement:
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
This device is going to be operated in 5.15~5.25GHz frequency range, it is restricted in indoor environment only.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation. For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not possible.
This device and it's antennas(s) must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with FCC multi-transmitter product procedures.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 21cm between the radiator & your body.
IC Statement:
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not possible.
Pour les produits disponibles aux États-Unis / Canada du marché, seul le canal 1 à 11 peuvent être exploités. Sélection d'autres canaux n'est pas possible.
This device and it's antennas(s) must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with IC multi-transmitter product procedures.
Cet appareil et son antenne (s) ne doit pas être co-localisés ou fonctionnement en association avec une autre antenne ou transmetteur.
The device for the band 5150-5250 MHz is only for indoor usage to reduce potential for harmful interference to co-channel mobile satellite systems.
Les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux.
IC Radiation Exposure Statement:
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 21cm between the radiator & your body.
Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 21 cm de distance entre la source de rayonnement et votre corps.
COPYRIGHT © 2016 HITRON TECHNOLOGIES, INC.
0440010241N0
Loading...