HiTi P110 User Manual
HiTi
User Manual
www.hiti.com
HiTi P110S user manual
General Information
Copyrights
All rights reserved. The information contained in this user guide is subject to change without notice. HiTi Digital,
Inc. makes no warranty with regard to the material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. HiTi Digital, Inc. will not be liable for errors contained herein or for
incidental or consequential damages in connection with the furnishing, performance, or use of the material.
Safety Precautions
1. Never attempt to disassemble or modify the printer. Doing so may lead to electric shock or printer malfunction.
2. Do not allow liquids near the printer, which may lead to electric shock or fire.
3. Do not use the printer if the printer body is damaged.
4. Avoid plugging the printer into a socket being used by couple appliances.
5. Do not place the printer on an unstable cart, stand, or table.
6. Make sure the printer is operated under the type of power indicated on the marking label. If you are not sure
the type of power, please consult your dealer or local power company for detail.
7. Do not block the air vents to protect the printer from overheating.
8. Do not insert or drop metallic, flammable, or other foreign substances into the machine.
9. Always unplug the printer for servicing.
10. An approved power cord greater or equal H05VV-F, 2X or 3G, 0.75mm must be used.
2
FCC Notice
Do not make any changes or modifications to the equipment unless otherwise specified in the instruction.
This equipment has been tested and found to comply with the limits f
or a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. Hwever, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Ȟ1ȟReorient or relocate the receiving antenna.
Ȟ2ȟIncrease the separation between the equipment and receiver.
Ȟ3ȟNever push objects into this equipment through cabinet openings, which may touch dangerous voltage points
or short out parts that could lead to a fire or electric shock.
Ȟ4ȟNever spill liquid on this equipment.
Ȟ5ȟConnect the equipment into an outlet on a circuit difference from that to which the receiver is connected.
Trademarks
Microsoft, MS-DOS, and Windows are registered trademarks of Microsoft Corporation. Adobe and Acrobat are
registered trademarks of Adobe Systems Incorporated. Mac, Macintosh, and Mac OS are trademarks of Apple
Computer, Inc., registered in the U.S. and other countries. Pentium is a U.S. trademark of Intel Corporation.
All other trademarks or registered trademarks are properties of their respective companies.
i
Table of Content
HiTi P110S user manual
General Inofrmation
ƦCopyrights
ƦSafety Precautions
ƦFCC Notice
ƦTrademarks
1. Check the Package Content
ƦAcquiring the Latest Software
2. Comprehend P110S
ƦFront view
ƦLED indicators 3
ƦBack view
ƦInternal view
ƦOptional Consumables
Photo Print Pack
ƦOptional Accessories
Battery Pack
Carrying Bag
Cleaning Kit
3. Installing P110S
ƦInstalling the Ribbon Cartridge
ƦLoading the Photo Paper
ƦPowering Up the Printer
Powering Up the Printer with the AC adapter
Powering Up the Printer with the Fully Charged Battery Pack(Optional)
4. Using the Battery Pack (Optional)
ƦPowering Up the Printer with the Battery Pack
ƦHandling of the Battery Pack
i
i
i
i
i
2
2
3
3
3
4
4
4
4
5
5
5
6
7
7
7
5. Standalone Printing
ƦPrint Photos Without a PC
ƦHome Menu Introduction
ƦMain Function Introduction
Quick Print
Multiple Print
Print All
ID Photo
Event Photo
Setup
ƦPrinter Setting
ƦPrintout Setting
ƦSpecial Function Introduction
Shortcut editing
Template setting
Cleaning mode
Print Count
PIN Code
LCD Adjustment
Color Setting
Image Adjuster & Enhancer
Power Management
6. PC-Link Printing
ƦConnecting the PC and Printer
ƦInstalling the Printer Driver
ƦInstalling the iDQuickDesiree
7. Troubleshooting
ƦIndicator Status
8. P110S Specification
9. Customer Service Information
ƦOnline Support
ƦGlobal Sites
9
10
11
11
18
25
25
25
25
26
26
27
28
28
28
1
HiTi P110S user manual
1. Check the Package Content
Before using photo printer P110S, please check the package content for following items*:
Photo Printer - P110S
Power Cord USB Cable Master CD
Quick Guide * Printer Cleaning Kit
Paper Cassette
Adapter
Note
Package content may vary in different regions. For any question about your printer,
*
please contact your HiTi representative
Printer Cleaning Kit includes cleaning kit user guide and cleaning paper.
*
Acquiring the Latest Software
HiTi website provides the latest driver, application, user manual etc for users to download. Please log on to
www.hiti.com for more information. If there is any question toward HiTi product, please contact your local
service center for detail.
2
2. Comprehend the P110S
Front View
Power Switch
2.5” LCD Panel
Function Buttons
Memory Card /
USB host Slots
Paper Cassette Button
Paper Cassette
Paper Exit
Ribbon Door
HiTi P110S user manual
LED indicators
Indications Descriptions
(Printer Status)
EDIT
ESC
Directional Pad
Directional Pad
Hot Key
Print
Note: Users are allowed to select favored ID formats as shortcuts.
Power
OK
Directional Pad
Directional Pad
Printer Status
Battery Status
Printing Status
Flashing red light: Error (# of blinks following the
factory standard)
Flashing green light: Power on but printer not ready yet
Steady green light: Power on and printer ready
(Battery status)
(Printing status)
Flashing orange light: Low battery
Steady orange light: Battery charging
Off: Battery fully charged
Flashing blue light: Ready to print
Steady blue light: Printing in action
Off: Not ready to print
3
HiTi P110S user manual
Back View
Back Panel
Release Button
Back Panel
USB Socket
Power Socket
Optional Consumables
Photo Paper / Stickers*
Internal View
Battery Slot
Paper Guide
Door
Battery Lever
Ribbon
x 60 sheets x 1 cartridge
Note
1. It is recommended to load no more than 50 sheets of stickers into the cassette.
2. Do NOT roll the ribbon manually to prevent the ribbon skip.
3. Be sure to bend the perforated strip down from the printable side and then bend up to tear off completely.
(See below illustration)
A B C
Optional Accessories
ƦBattery Pack ƦCarrying Bag ƦCleaning Kit
4
3. Installing the P110S
Remove the Cushion Inside the P110S Before Using the Printer
HiTi P110S user manual
Be sure to remover
the cushion inside
P110S before
using.
Installing the Ribbon Cartridge
Open the ribbon door and install the ribbon cartridge, then close the ribbon door
Open the ribbon door
Loading the Photo Paper
1. Follow the instruction marked on the plastic bag for correct paper handling
Users may keep the
cushion for protection
during transportation.
Insert the ribbon
cartridge.
wider strip
2. Press the paper cassette button to release the paper cassette. Load photo papers into the paper cassette
and then close the cover
Load photo papers into the
paper cassette and then
close the cover, insert the
Press the paper
cassette button to
release the paper
cassette.
paper cassette into the slot.
Ɏ4”x6” photo paper and 4”x6”
sticker (1x1) are both
compatible with P110S.
It is recommended to load no
more than 50 sheets of stickers
into the cassette.
5
Power up the Printer
Power up the printer with AC adapter
Connect the adapter and the power cord,
and plug into the printer and power slot.
HiTi P110S user manual
Turn on the power.
(Optional) Power up the printer with the fully charged battery pack.
Press back panel release
button.
Insert battery into
battery slot.
Turn on the power.
Note
1. Printer will be automatically turned off when cease working for a period of time (user defined).
2. To charge the battery pack, see user manual for detail.
Caution: Please do not remove the power cord during the printing operation even
when the presence of the battery. Ribbon/Paper jam may occur.
6
HiTi P110S user manual
4. Using the Battery Pack*
Power up the Printer with the fully charged battery pack
ƦPress back panel release button. ƦInsert battery into battery slot. ƦTurn on the power.
* Note
1. Printer will be automatically turned off when cease working for a period of time (user defineable), see Special
Function/ Power Management for detail.
2. As to save battery energy, please refer to Special Function/ Power Management.
Handling of the Battery Pack
1. Checking the battery status
Indication Description
Fully-charged battery.
To use the printer for a long time, we recommend using fully-charged battery or
recharging the battery before using.
Low battery power.
Operations other than printing are possible. Change it with a fully charged battery or
recharge the battery pack with the printer’s compact power adapter immediately.
The adaptor is connected.
7
HiTi P110S user manual
2. Proper Usage and Handling
1. Do not use the battery pack in products other than those recommended by HiTi.
2. Do not attempt to open the battery pack.
3. Never make the battery pack short circuited. The battery pack may be easily short-circuited by putting them on
conductive material.
4. Seal break may cause electrolyte leakage which may lead to short circuit, smoke emission, bursting and/or
ignition.
5. Store or charge the battery pack at low temperature ( below 20? is recommended, see “Specification” session
for detail ), low humidity, no dust and no corrosive gas atmosphere, not in direct sunlight or close to a heating
source.
6. It’s recommended to recharge the battery packs periodically for more than 6 months storage.
3. Charging the Battery Pack
1. Be sure to use only Hiti P110S printer or PBC-110 charger to recharge the battery pack.
2. To fully charge the battery pack, you need to insert the battery pack into P110S printer or PBC-110 charger and
plug in the compatible adapter, with continuous electricity supply, it takes approximately 3.5 hours on P110S
and 2 hours on PBC-110 charger.
ƦHiTi recommends to recharge the battery pack in a temperature of 0~+40ƫ (41~104ƭ)
ƦCharging time varies according to the ambient temperature and charge state.
ƦThis battery pack is a Li-ion battery pack, no need to discharge it completely before recharging.
3. Fully charge the battery before first use.
4. To ensure of using a fully charged battery pack, it is recommended to charge the battery pack till it’s fully
charged before using.
ƦThe battery pack discharges naturally.
5. The battery pack capacity may diminish substantially after a period of using time.
ƦAfter approximately 200 times of recharging, the fully recharged capacity may drop to 70% in normal operating
8
Loading...