HITEC 1806/18, 2204/18, 2206/18, 2208/18, 2212/20 Operation Manual

INTEGRATED POWER SYSTEM

operation manual

Introduction:

Thank you for purchasing Hitec’s Energy Propel integrated Power System. Featuring a high
performance, high eciency brushless motor integrated with our Energy Rotor electronic speed
control! This combination creates an easy straighforward installation and clean wiring layout for
your multi-rotor

Connecting Your Motor:

1. Connect the power wires from the Motor to the power distribution board or battery.

2. Connect the signal cable to the ight controller according to the instruction.
Note: The red wire from the Motor should connect to the Positive + and black to the Negative (-)
side of the Power Distribution Board.

Power

Distribution

Board

-

+

Red

Black

Battery

-

+

-

+

Signal Wire

(white & black)

Power Wires

Energy Propel

180X & 22XX

Series

ONE YEAR LIMITED WARRANTY:

For a period of two years from the date of purchase HITEC RCD USA, INC. shall REPAIR OR REPLACE, at
our option, defective equipment covered by this warranty, otherwise the purchaser and/or consumer
is responsible for any charges for the repair or replacement of the product. This warranty does not
cover cosmetic damages and damages due to acts of God, accident, misuse, abuse, negligence,
improper installation, or damages caused by alterations by unauthorized persons or entities. This
warranty only applies to the original purchaser of this product and for products purchased and used
in the United States of America, Canada and Mexico. For more information regarding this warranty
visit us on the web at www.hitecrcd.com or contact us @ service.hitecrcd.com

Hitec RCD USA, Inc., Customer Service Center, 12115 Paine St., Poway CA 92064

[phone]

Model 1806/18 2204/18 2206/18 2208/18 2212/20 2216/20

Stator Diameter 18 mm 22 mm 22 mm 22 mm 22 mm 22 mm
Stator Thickness 6 mm 5 mm 7 mm 8 mm 12 mm 16 mm
Number of Poles 12N 14P 12N 14P 12N 14P 12N 14P 12N 14P 12N 14P
KV Rating 2300 KV 2300 KV 2200 KV 1900 KV 1000 KV 900 KV
Resistance 0.161Ω 0.091Ω 0.047Ω 0.051Ω 0.119Ω 0.161Ω
Idle Current 0.41A 0.73A 0.96A 0.86A 0.44A 0.55A
Maximum Watts 180W 160W 200W 220W 320W 370W
Input Voltage 2-3S LiPo 2-3S LiPo 2-3S LiPo 2-4S LiPo 2-4S LiPo 2-4S LiPo
Shaft Diameter M5x11mm M5x11mm M5x11mm M5x11mm M5x11mm M5x11mm
ESC Cont. Current 18 Amps 18 Amps 18 Amps 18 Amps 20 Amps 20 Amps
ESC Burst. Current 28 Amps 28 Amps 28 Amps 28 Amps 28 Amps 28 Amps
Recommended Prop Size 3 - 5 in 5 - 6 in 5 - 6 in 5 - 6 in 8 - 10 in 9 - 11 in
Weight 35 g 33.5 g 40.5 g 42.5 g 53.5 g 65.5 g