Hitachi SP20 Revised RF Exposure Manual info

Disposal of Lithium Ion (LiIon) Batteries

For safe disposal options of your LiIon batteries, contact your nearest
Sprint-authorized service center.

Special Note: Be sure to dispose of your battery properly. In some areas,

the disposal of batteries in household or business trash may be
prohibited.

Note: For safety, do not handle a damaged or leaking LiIon battery.

Acknowledging Special Precautions and
the FCC Notice

FCC Notice

The phone may cause TV or radio interference if used in close proximity
to receiving equipment. The FCC can require you to stop using the phone
if such interference cannot be eliminated.

Vehicles using liquefied petroleum gas (such as propane or butane) must
comply with the National Fire Protection Standard (NFPA-58). For a copy
of this standard, contact the National Fire Protection Association, One
Batterymarch Park, Quincy, MA 02269, Attn: Publication Sales Division.

Cautions

Any changes or modifications to your phone not expressly approved in
this document could void your warranty for this equipment, and void
your authority to operate this equipment. Only use approved batteries,
antennas and chargers. The use of any unauthorized accessories may be
dangerous and voids the phone warranty if said accessories cause
damage or a defect to the phone.

Although your phone is quite sturdy, it is a complex piece of equipment
and can be broken. Avoid dropping, hitting, bending or sitting on it.

Body-Worn Operation

To maintain compliance with FCC RF exposure guidelines, if you wear a
handset on your body, use the Sprint supplied or approved carrying case,
holster or other body-worn accessory. If you do not use a body-worn

Section 4: Safety Guidelines and Warranty Information

1894A: Safety

accessory, ensure that the antenna is at least 0.394 inch (1 centimeter)
from your body when transmitting. Use of non-Sprint approved
accessories may violate FCC RF exposure guidelines.

For more information about RF exposure, please visit the FCC Web site at

www.fcc.gov.

Specific Absorption Rates (SAR) for Wireless Phones

The SAR is a value that corresponds to the relative amount of RF energy
absorted in the head of a user of a wireless handset.

The SAR value of a phone is the result of an extensive testing, measuring
and calculation process. It does not represent how much RF the phone
emits. All phone models are tested at their highest value in strict
laboratory settings. But when in operation, the SAR of a phone can be
substantially less than the level reported to the FCC. This is because of a
variety of factors including its proximity to a base station antenna, phone
design and other factors. What is important to remember is that each
phone meets strict federal guidelines. Variations in SARs do not represent
a variation in safety.

All phones must meet the federal standard, which incorporates a
substantial margin of safety. As stated above, variations in SAR values
between different model phones do not mean variations in safety. SAR
values at or below the federal standard of 1.6 W/kg are considered safe for
use by the public.
The highest reported SAR values of SH-P300 are:
PCS mode (Part 24) - Head: 1.600 W/kg; Body-worn: 0.861 W/kg

FCC Radiofrequency Emission

This phone meets the FCC Radiofrequency Emission Guidelines. FCC ID
number: ABLSP20. More information on the phone’s SAR can be found
from the following FCC Web site:

Section 4: Safety Guidelines and Warranty Information

190 4A: Safety

http://www.fcc.gov/oet/fccid.