To obtain the best performance and ensure years of trouble free use, please read this instruction manual
completely.
32CNH2 EN13/25/05, 2:301
SAFETY PRECAUTION
●
Please read the “Safety Precaution” carefully before operating the unit to ensure correct
usage of the unit.
●
Pay special attention to signs of “ Warning” and “ Caution”. The “Warning” section
contains matters which, if not observed strictly, may cause death or serious injury. The
“Caution” section contains matters which may result in serious consequences if not observed
properly. Please observe all instructions strictly to ensure safety.
●
“ ” sign in attached figure indicates prohibition.
●
Please keep this manual after reading.
PRECAUTIONS DURING INSTALLATION
●
!
WARNING
!
CAUTION
Please ask your sales agent or qualified technician for the installation
of your unit. Water leakage, short circuit or fire may occur if you install
the unit yourself.
●
Please use earth line.
Do not place the earth line near water or gas pipes, lightning-conductor,
or the earth line of telephone. Improper installation of earth line may
cause electric shock.
●
A circuit breaker should be installed depending on the mounting site of
the unit. Without a circuit breaker, the danger of electric shock exists.
●
Do not install near location where there is flammable gas. The outdoor
unit may catch fire if flammable gas leaks around it.
●
Please ensure smooth flow of water when installing the drain hose.
!
!
!
WARNING
●
!
W
A
R
N
●
I
N
G
PRECAUTIONS DURING SHIFTING OR MAINTENANCE
●
Should abnormal situation arises (like burning smell), please stop operating
the unit and turn off the circuit breaker. Contact your agent. Fault, short circuit
or fire may occur if you continue to operate the unit under abnormal situation.
●
Please contact your agent for maintenance. Improper self maintenance may
cause electric shock and fire.
●
Please contact your agent if you need to remove and reinstall the unit.
Electric shock or fire may occur if you remove and reinstall the unit yourself
improperly.
PRECAUTIONS DURING OPERATION
Avoid an extended period of direct air flow for your health.
●
Do not put objects like thin rods into the panel of blower and suction side
because the high-speed fan inside may cause danger.
Do not use any conductor as fuse wire, this could cause fatal accident.
●
During thunder storm, disconnect and turn off the circuit breaker.
32CNH2 EN13/25/05, 2:302
– 2 –
PRECAUTIONS DURING OPERATION
●
The product shall be operated under the manufacturer specification and
not for any other intended use.
●
ENGLISH
Do not attempt to operate the unit with wet hands, this could cause fatal
accident.
●
When operating the unit with burning equipments, regularly ventilate the
room to avoid oxygen insufficiency.
●
Do not direct the cool air coming out from the air-conditioner panel to face
household heating apparatus as this may affect the working of apparatus
such as the electric kettle, oven etc.
●
Please ensure that outdoor mounting frame is always stable, firm and
without defect. If not, the outdoor unit may collapse and cause danger.
●
Do not splash or direct water to the body of the unit when cleaning it as this
may cause short circuit.
!
●
C
A
U
T
I
O
N
Do not place plants directly under the air flow as it is bad for the plants.
●
Please switch off the unit and turn off the circuit breaker during cleaning, the
high-speed fan inside the unit may cause danger.
●
Turn off the circuit breaker if the unit is not to be operated for a long period.
●
Do not climb on the outdoor unit or put objects on it.
●
Do not put water container (like vase) on the indoor unit to avoid water
dripping into the unit. Dripping water will damage the insulator inside the
unit and causes short-circuit.
●
When operating the unit with the door and windows opened, (the room humidity is always above
80%) and with the air deflector facing down or moving automatically for a long period of time,
water will condense on the air deflector and drips down occasionally. This will wet your furniture.
Therefore, do not operate under such condition for a long time.
●
If the amount of heat in the room is above the cooling capability of the unit (for example: more
people entering the room, using heating equipments and etc.), the preset room temperature
cannot be achieved.
– 3 –
32CNH2 EN13/25/05, 2:303
NAMES AND FUNCTIONS OF EACH PART
INDOOR UNIT
AIR FILTER
To prevent dust from coming into the indoor unit.
(Refer page 16)
POWER PLUG (NOT PROVIDED)
INDOOR UNIT INDICATORS
Light indicator showing the operating condition.
(Refer page 5)
SUCTION GRILL (AIR INLET)
OUTDOOR UNIT
HORIZONTAL DEFLECTOR
DEFLECTOR (AIR OUTLET)
(Refer page 12)
REMOTE CONTROL
Send out operation signal to the indoor unit. So as
to operate the whole unit.
(Refer page 6)
DRAIN PIPE
Condensed water drain to outside.
CONNECTING CORD
AIR INLET (BACK, LEFT SIDE)
AIR OUTLET
●
VERTICAL
MODEL NAME AND DIMENSIONS
MODEL
RAS-32CNH2
RAC-32CNH2
32CNH2 EN13/25/05, 2:304
WIDTH (mm)
798
820
– 4 –
HEIGHT (mm)
265
520
DEPTH (mm)
168
280
OPERATION INDICATOR
SELECTOR SWITCH
ENGLISH
TEMPORARY SWITCH
AUTO START
Use this switch in order to set
the unit to automatically switch
ON after the power supply
resuming from the power failure.
NORMAL
Use this switch in order to
prevent the unit from switch ON
after the power supply resuming
from the power failure.
SELECTOR SWITCH IS
PRESET AT NORMAL
POSITION.
INDOOR UNIT INDICATORS
AUTO
TEMPORARY
NORMAL
START
SWITCH
OFF
ON
POWER SWITCH
OPERATION LAMP
This lamp lights during operation.
The OPERATION LAMP flashes in the following cases
during heating.
(1) During preheating
For about 2–3 minutes after starting up.
(2) During defrosting
Defrosting will be performed about once an hour
when frost forms on the heat exchanger of the
outdoor unit, for 5–10 minutes each time.
Use this switch to start and
stop when the remote
controller does not work.
Normally do not use this
button.
32CNH2 EN13/25/05, 2:305
FILTER LAMP
When the device is operated for a total of about 100
hours, the FILTER lamp lights to indicate that it is time
to clean the filter. The lamp goes out when the POWER
SWITCH set to OFF and ON again.
SIGNAL RECEIVER
There will be a beep sound when this receiver receives
signal from remote controller.
TIMER LAMP
This lamp lights when the timer is working.
– 5 –
NAMES AND FUNCTIONS OF REMOTE CONTROL UNIT
■ This controls the operation function and timer setting of the room air conditioner. The range of
control is about 4 meters. If indoor lighting is controlled electronically, the range of control may be
shorter.
Signal Transmission
START/STOP Button
Press this button to start operation.
Press it again to stop operation.
FUNCTION Button
Select the operation mode.
( Page 8)
SLEEP Button
Use this button to set the sleep timer.
( Page 10)
Reserve Button
Timer setting reservation.
OFF TIMER Button
Select the turn OFF time.
ON TIMER Button
Select the turn ON time.
HIT ACHI
˚
C
Hr.
°C
Transmission Sign
The transmission sign blinks
when a signal has been send.
TEMPERATURE Button
Room temperuture setting.
Value will change more quickly
when keep pressing.
( Page 7)
FAN SPEED Button
Select the fan speed for
cooling and heating mode.
( Page 8)
AUTO SWING Button
Control the angle of the
horizontal air deflector.
( Page 12)
CANCEL Button
Cancel timer reservation.
Precautions for Use
● Do not put the remote controller in direct
sunlight and high temperature.
● Do not drop it on the floor, and protect
it from water.
● If you press the FUNCTION button
during operation, the air conditioner may
stop for about 3 minutes for protection
before you can start it again.
You can use the remote controller by fixing it on the
wall with the accessory parts.
● Before fixing it,
HOLDER
make sure the
unit can be
controlled by the
remote control
unit at the fixing
REMOTE
CONTROLLER
position.
– 6 –
32CNH2 EN13/25/05, 2:306
Loading...
+ 14 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.