Hitachi CV-90CY BS RBL How to use

How to use your
HITACHI
VACUUM CLEANER

MODEL CV-90CY BS RBL

PART INDENTIFICATION

Cord storage hooks

Flexible hose

Carrying handle

Hose storage hook
& cord storage
hook

Handle

Filter maintenance
sign

Clamp

Dust
compartment

Front cover

Furniture guard

Handle cover

ON-OFF switch

Duct hose

Curved joint pipe

Dusting brush

Extension pipes

Crevice nozzle

Handle release pedal
(3 positions)

Fig.1

HOW TO OPERATE

TO INSTALL THE HANDLE (Fig. 2)

1. Insert the handle 1 into the opening on the top of the cleaner and )

tighten screw

2) Fix the handle cover to handle firmly. When you take it off, insert a screwdriver
(straight type) in the side hole of handle cover and detach it.

2

Fig.2

Handle cover

-1-

Side hole

ON-OFF SWITCH

Turn cleaner on or off by pushing downward on the
power switch

3

(Fig. 3)

Fig.3

CORD STORAGE AND RELEASE (Fig. 4)

1. To store the cord, turn the upper cord storage hook 4
to the upward position, and wrap the cord around the
hooks.

2. To release the power cord, turn the upper cord storage
hook 4 downward, then pull off the complete cord.

3. To help secure the cord during use, fix it on the upper
cord storage hook

5

HANDLE POSITION (Fig. 5)

To change the position of the handle, first press with foot
on the handle release pedal at the rear of the cleaner, and
then lower the handle.

(A) Upright position: When the handle is in this

position the rotary brush is automatically raised
away from the floor.

(B) Normal working position: This position allows you

to raise the front of the nozzle head to clear steps.

(C) Low position: For reaching under low furniture

to raise the front of the nozzle head to clear steps.

5

4

Fig.4

Fig.5

NOTE: The handle should always be in upright

position when cleaning tools are used.

-2-

AUTOMATIC HEIGHT CONTROL

Fig.9

Flap Flap opens at corner

The HITACHI vacuum cleaner has an automatic height control, which adjusts the
nozzle to the proper height of any carpet pile.

(Fig. 6)

Fig.6

DUST COMPARTMENT OPERATION (Fig. 7)

When the orange sign 6 appears continuously in the window,
empty the dust compartment.
Never allow the dust compartment to become so full that
the dirt will block the passage to the compartment.
Empty the dust compartment frequently when using the cleaner
on new carpets, due to rapid accumulation of carpet fluff. And
maintain the filters along Filter Care on Page 6.
In case the orange sign is still visible after emptying the dust
compartment, turn the cleaner off, unplug the cord and check
whether the duct hose is clogged. If so remove blockages.

NOTE: If the cleaner is used when the orange sign

appears in the window, it will not draw enough
air and the motor may overheat and may
eventually burn out.

CARRYING HANDLE (Fig. 8)

To move your cleaner from room to room, carry it by
the carrying handle
it on the rear wheels.

7 on the back of the cleaner or roll

EDGE CLEANING (Fig. 8)

Brushed edge cleaning is provided on the both sides of
the cleaner to remove imbedded dirt in carpet close to
the skirting board or wall.
Guide each side of the cleaner parallel to the wall or
furniture.

6

Fig.7

7

Rear wheels

Edge cleaning

Fig.8

FRONT EDGE CLEANING (Fig. 9)

The front edge cleaning is a special head function that
provides good performance at the corner and wall
edges of a room.

-3-