Additional Information ......................................................... 33
2
Warning
To reduce the risk of re or electric shock, do not expose this apparatus
to rain or moisture.
To avoid electric shock, do not open the cabinet. Refer servcing to
qualied personnel only.
The lightning flash with arrowhead symbol, within an
equilateral triangle is intended to alert the user to the presence
of uninsulated dangerous voltage within the product's
enclosure that may be of sufcient magnitude to constitute a
risk of electric shock.
3
Warning
The exclamation point within an equilateral triangle is intended
to alert the user to the presence of important operating
and maintenance (servicing) instructions in the literature
accompanying the appliance.
Batteries or batteries installed apparatus shall not be exposed to
excessive heat such as sunshine, re or the like.
This graphical symbol is located on the bottom of the unit.
Precautions
To prevent re or shock hazard, do not place objects lled with
liquids, such as vases, on the apparatus.
The player is not disconnected from the AC power source (mains) as
long as it is connected to the wall outlet, even if the player itself has
been turned off.
Install this unit so that AC power cord can be unplugged from the wall
socket immediately in the event of trouble.
The nameplate is located on the bottom of the player.
Installation
Do not install this player in a conned space, such as a bookshelf or
similar unit.
4
Warning
FCC Notice
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for
a class B digital Device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
5
Warning
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
The manufacturer is not responsible for any radio or TV interference
caused by unauthorized modifications to this equipment. Such modifi-
cations could void the user’s authority to operate the equipment.
6
FCC/IC Statement
Industry Canada Notice
This device complies with industry Canada license-exempt RSS
standards(s).Operation is subject to the following two conditions:(1)this
device may not cause interference,and (2)this device must accept any
interference ,including interferernce that may cause undesired opera-
tion of the device.
Le présent appareil est conforme aux CNR d’lndustrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes: (1) I’appareil ne doit pas produire
de brouillage, et (2) I’utilisateur de I’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
Under industry Canada regulations,this radio transmitter may only
operate using an antenna of a type and maximum(or lesser)gain approved for the transmitter by industry Canada. To reduce potential radio
interference to other users,the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power(e.i.r.p.) is not
more than that necessary for successful communication.
7
FCC/IC Statement
Conformément à la réglementation d’lndustrie Canada, le présent
émetteur radio peut fonctionner avec une antenne d’un type et d’un
gain maximal (ouinférieur) approuvé pour l’ émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à
l’intention des autres utilisateurs, il faut choisir le type d’antenne et son
gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.)
ne dépasse pas l’intensité nécessaire à l’ établissement d’une communication satisfaisante.
FCC RF Safety Caution Statement
To satisfy FCC RF exposure requirements for mobile and base station
transmission devices, a separation distance of 20 cm or more should
be maintained between the antenna of this device and persons during
operation. To ensure compliance, operation at closer than this distance
is not recommended. The antenna(s) used for this transmitter must not
be co-located or operating in conjunction with any other antenna or
transmitter.
RF Exposure Statement for Canada
Notice: To satisfy IC RF exposure requirements for mobile and base
8
FCC/IC Statement
station transmission devices, a separation distance of 20 cm or more
should be maintained between the antenna of this device and persons
during operation, To ensure compliance, operation at closer than this
distance is not recommended. The antenna(s) used for this transmitter
must not be co-located or operating in conjunction with any other antenna or transmitter.
Avis: Pour répondre à la IC d’exposition pour les besoins de base et
mobiles dispositits de transmission de la station, sur une distance
de séparation de 20 cm ou plus do it être maintenue entre I’antenne
de cet appareil et les personnes en cours de fonctionnement. Pour a
ssurer le respect, I’exploitation de plus près à cette distance n’est pas
recommandée. L’antenne (s) utilisé pour cet émetteur ne doit pas être
co-localisés ou fonctionner conjointement avec une autre antenne ou
transmetteur.
9
Important Safety Instructions
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the
manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers) that
produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type
plug. A polarized plug has two blades with one wider than the other.
A grounding type plug has two blades and a third grounding prong.
The wide blade or the third prong are provided for your safety. If the
provided plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly
at plugs, convenience receptacles, and the point where they exit
10
Important Safety Instructions
from the apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only with cart, stand, tripod, bracket, or table specified by
the manufacturer, or sold with the apparatus. When a
cart is used, use caution when moving the cart/apparatus
combination to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or when unused for
long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been dropped.
11
Loading...
+ 24 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.