HiRO H50219 User Manual

User Manual

10/100/1000Mbps PCIE LAN CARD

1

Contents

Chapter 1 Introduction .................................................................................................. 2

1.1 Overview of the product ...................................................................................... 2

1.2 Features ............................................................................................................. 2

1.3 LED Status ................................ ......................................................................... 2

Chapter 2 Installation Guide ......................................................................................... 2

2.1 Hardware Installation .......................................................................................... 3

2.2 Software Installation ........................................................................................... 4

2

Chapter 1 Introduction

1.1 Overview of the product

Congratulations on your purchase of this 10/100/1000Mbps PCIe LAN Card. The Adapter
provides the bandwidth capability to support high-end servers and workstations. With
Auto-negotiation, this card can run on three different speeds: 10Mbps at half and full
duplex, 100Mbps at half and full duplex, and 1000 Mbps at full duplex. When running at
1000Mbps, it provides a network throughput of 2 Gbps in full-duplex mode.

Instructions for installing and configuring this product can be found in this manual. Before
you install and use this product, please read this manual carefully for full exploiting the
functions of this product.

1.2 Features

 Compliance with IEEE802.3ab 1000BASE-T Gigabit Ethernet standards, IEEE802.3u

Fast Ethernet standards

 Plug-and-Play installation
 Support half and full duplex at 10Mbps, half and full duplex at 100Mbps,and full duplex

operation at 1000Mbps

 One build-in RJ45 connector
 Auto-Negotiation to the highest available speed
 Support IEEE802.1P Layer 2 Priority Encoding
 Support Full Duplex flow control (IEEE 802.3x)
 Support IEEE 802.1Q VLAN tagging
 Build-in FIFO buffers reduce overhead of memory transfers
 Support Microsoft NDIS5 Checksum Offload (IP, TCP, UDP) and large send offload
 Support Jumbo Frame transfers
 Two LED indicators: 10/100/1000M Link, 10/100/1000M Act
 Driver support for:

Microsoft Windows Series.
Linux

Novell Netware Series

MacOS

1.3 LED Status

The Adapter features two LED indicators:
LINK/ACT: Steady green indicates good linkage between the adapter and its supporting
server or switch. Flashing green indicates activity (transmitting or receiving) between the
adapter.
1000M: The LED indicator lights green when one 1000 Mbps device is connected to the
adapter.