HIOTH TECHNOLOGY CO., LTD CT-SMZW2004-ES User Manual

HIOTH User Manual

HIOTH TECHNOLOGY CO.,LTD.

PIR MOTION DETECTOR

Introduction

The Motion Detector is a Z-Wave enabled device which is fully compatible with any Z-Wave
enabled network. Z-Wave enabled devices displaying the Z-Wave logo can also be used with it
regardless of the manufacture, and ours can also be used in other manufacturer’s networks, This
Motion Detector can control our modules via controller settings. Inclusion of this Motion Detector
on other manufacture’s Wireless Controller menu allows remote turn on of connected modules w­hen the detector is triggered.

The Motion Detector is designed with two detecting sensors, Passive Infra Red (PIR) sensor
and light sensor, in order to fulfill the purpose of security and home automation. Once night falls,
the percentage of ambient illumination is lower than preset value. If a person moves within or
across the device field of vision, a trigger radio signal will be transmitted so as to turn on the con­nected lightings for better illumination.

CT-SMZW2004-ES

PIR Motion Detector

HIOTH User Manual

HIOTH TECHNOLOGY CO.,LTD.

Technical Information

 Compatible with any Z-Wave network controller

 Battery powered and cost savings

 Support the scene control

Specifications

 Radio protocol: Z-Wave 868.42MHz EU
 Power supply: DC 4.5V(1.5V AA*3)

 RF range：25m (in an open area of the wireless controller and the latest line-of-sight between

Z-Wave receiving module)

 Operation Frequency: 908.42 MHz (SP814-2) / 921.42 MHz (SP814-9)
 PIR Detection Coverage: Wall-Mounted:

Up to 10m x 110 ° (at 1.8m mounting height& 25 ° C)
Ceiling-Mounted:
Up to5m x 360 ° (at2.8m mounting height& 25 ° C)

 Dimension：85 mm x 85 mm x 45 mm

Operation

NOTE:

① Lens Cover
② Photocell Sensor
③ PIR Sensor
④ Two-Color Indication LED(red & green)

HIOTH User Manual

HIOTH TECHNOLOGY CO.,LTD.

⑤ Link Key

Fig.1

Z-WAVE NETWORK INCLUSION

In the rear casing, there is a link key which is used to carry out inclusion, exclusion, association
or reset. When the detector is first powered up, the LED flashes on and off alternately and repeate
dly at 2-second intervals. It implies that it has not been assigned a node ID and cannot work with
Z-Wave enabled devices.

1) Connect the power supply, and make sure that device in a state of "No node ID" (2-second

on, 2-second off).

2) Choose "Z-Wave" to enter the Network Inclusion mode on the APP, then click " ".

3) Pressing link key 3 times within 1.5 second (Detector beeps when link key is pressed.).

4) When prompt a message “Request Access Success”, please go to the device list interface, and

refresh the device list, the device will be displayed.

Z-WAVE NETWORK EXCLUSION

1) Make sure the device is connected to the power supply.

2) Remove the device on the APP, then click "finish".

3) Pressing link key 3 times within 1.5 second (Detector beeps when link key is pressed.).

4) Please go to the device list interface, and refresh the device list, the device will not be
displayed.