Hioth CT-EDZW4001-MH User Manual

HIOTH User Manual

CT-EDZW4001-MH

PM2.5 Monitor

PM2.5 Monitor

Introduction

PM2.5 Monitor is an air quality controller which compatible with Z-Wave technology, it is mainly
used to monitor PM2.5 concentration in industrial, agricultural, and residence environment, while
monitoring the indoor temperature and humidity. Device can be included into any Z-Wave net-

work, and is compatible with any other Z-Wave certified devices.

Technical Information

 Compatible with any Z-Wave network controller
 Monitor PM2.5, temperature and humidity

 High accuracy , good real-time performance and low cost

HIOTH TECHNOLOGY CO.,LTD.

HIOTH User Manual

Specifications

 Radio protocol: Z-Wave
 Radio Frequency: 868.42MHz EU
 Power supply: AC220V, 50Hz
 Self-dissipation: <3W
 PM2.5 detection range: 0-999.9 ug/m3

 Temperature range：-9.0～50 ℃

 Humidity range: 0%～99% RH

 Hole Pitch：60mm or 82mm

 Installation: wall-mounted (Vertical)
 Housing: Tempered glass+ PC Alloy

 Dimension：85mm x 135mm x 33mm

Installation Instructions

Device is suggested to be installed indoor, a place with around 1.5m height above the floor where
represents the average PM2.5 concentration. It should be away from direct sunlight, any cover, or
any heat source, to avoid false signal for detection.

Notice!

1. Device must be wall-mounted vertically. Do not lay it flat or upside down while working.

2. Do not mounted it in a wind gap, or cover its bottom, which may affect the detected data.

PM2.5 MOTION INSTALLATION

1) Follow the wiring diagram to insert all wires into right terminals and tighten screws.

HIOTH TECHNOLOGY CO.,LTD.