
LR8450-01メモリハイロガー用
無線ユニット
Wireless Modules Dedicated to
LR8450-01 Memory HiLogger
取扱説明書 / Instruction Manual
Dec. 2021 Revised edition 1
LR8530A960-01 21-12H
JA/EN
製品名
LR8450-01用の無線ユニットには次の6 種類があります。
LR8530 ワイヤレス電圧・温度ユニット
WIRELESS VOLTAGE/TEMP UNIT
LR8531
LR8532
LR8533
LR8534
LR8535
ワイヤレスユニバーサルユニット
WIRELESS UNIVERSAL UNIT
ワイヤレス電圧・温度ユニット
WIRELESS VOLTAGE/TEMP UNIT
ワイヤレス高速電圧ユニット
WIRELESS HIGH SPEED VOLTAGE UNIT
ワイヤレスひずみユニット
WIRELESS STRAIN UNIT
ワイヤレス CANユニット
WIRELESS CAN UNIT
はじめに
このたびは、HIOKI LR8450-01 メモリハイロガー用無線ユ
ニットをご選定いただき、誠にありがとうございます。無線
ユニットは、Z3230 無線 LANアダプタを取り付けることで、
LR8450-01 に無線接続できます。使用上の注意、仕様など
の詳細は、LR8450-01 に付属のクイックスタートマニュア
ルおよび取扱説明書 詳細編(PDF)をご覧ください。
無線 LAN について
LR8450-01 メモリハイロガーと Z3230 無線 LANアダプタ
は、2.4 GHz 帯域の電波を使用しています。本製品を使用す
る上で無線局の免許は必要ありませんが、次のことにご注意
ください。
危 険
心臓ペースメーカーなどの医療用機器の近くで使用
しない
本製品の電波がペースメーカーや医療機器の動作に
影響を及ぼし、誤動作による事故を引き起こすおそ
れがあります。
警 告
医療機器、原子力設備や機器、航空宇宙機器、輸送
設備や機器などの人命に関わる設備や機器、および
高度な信頼性を必要とする設備や機器やシステムで
は使用しない
これらの用途に本製品を使用し、人身事故、損害な
どが生じても弊社はいかなる責任も負いかねます。
Z3230に装着されているねじを締め付ける
3
注 記
Z3230に装着されているねじを使用する
指定以外のねじを使用すると、無線ユニットが破損
するおそれがあります。
壁に取り付ける
用意するもの: 取り付け用ねじ M4 × 8 mm以上 ………… 2
取付板(付属品) …………………………… 1
皿ねじ M3 × 4 mm(付属品) ……………… 2
プラスドライバー(No.2) ………………… 1
付属のM3 × 4 mm の皿ねじ 2 本で、無線ユニットの
1
背面に取付板を取り付ける
安全に関する表記
本書では、リスクの重大性および危険性のレベルを以下のよ
うに区分して表記します。
危 険
警 告
注 意
注 記
回避しなければ、作業者が死亡または重傷に至る
切迫した危険があることを示します。
回避しなければ、作業者が死亡または重傷を負う
おそれがあることを示します。
回避しなければ、作業者が軽傷を負うおそれがあ
ることを示します。
機器などが破損するおそれがあることを示します。
梱包内容
LR8530 ワイヤレス電圧・温度ユニット
LR8531 ワイヤレスユニバーサルユニット
LR8532 ワイヤレス電圧・温度ユニット
LR8533 ワイヤレス高速電圧ユニット
LR8534 ワイヤレスひずみユニット
LR8535 ワイヤレス CAN ユニット ………… いずれか 1
Z3230 無線 LAN アダプタ ……………………………… 1
Z1008 ACアダプタ(接地形 2 極電源コード) ………… 1
取付板
……………………………………………………… 1
皿ねじ
結線確認ラベル(
取扱説明書(本書)
修理に出すときは
修理の際は、Z3230 無線LANアダプタを取り外し、Z3230
を無線ユニットと一緒に梱包してください。
M3× 4 mm ……………………………………… 2
LR8534のみ) ………………………… 1
………………………………………… 1
注 記
同一の周波数帯を使用する他の無線通信機器の近く
で、LR8450-01と無線ユニットを使用しない
通信が不安定になったり、他の機器の動作に影響を
与えたりするおそれがあります。
LR8450-01 と無線ユニット(Z3230 無線LAN アダ
プタ)は、それぞれの間の距離が見通しで30 m 以内
になるように設置する
LR8450-01 と無線ユニットとの間に障害物(壁、金
属の遮蔽物など)が無いように設置する
通信が不安定になったり、通信距離が短くなったり
するおそれがあります。
無線ユニットに Z3230 を
取り付ける
無線ユニットの電源を切り、ACアダプタを外す
1
入力ケーブルは接続しないでください。
無線ユニットの上面に、Z3230 無線LANアダプタを
2
装着する
Z3230を奥までしっかり差し込んでください。
注 記
M3× 4 mm の皿ねじを使用する
指定以外のねじを使用すると、機器が破損したり、取
付板から無線ユニットが外れたりするおそれがあり
ます。
背面
M4ねじ 2 本で、取付板を壁に取り付ける
2
取り付け用のねじは付属していませんので、市販品を
ご使用ください。
推奨ねじ:
取付板は、強固な壁などにしっかりと取り付ける
脱落により、人身事故または無線ユニットの破損を
引き起こすおそれがあります。
M4× 8 mm 以上
正面
注 意

Wireless Modules Dedicated to
LR8450-01 Memory HiLogger
Instruction Manual
Dec. 2021 Revised edition 1
LR8530A960-01 21-12H
EN
Safety notations
This manual classies seriousness of risks and hazard levels
as described below:
Indicates an imminently hazardous situation
DANGER
WARNING
CAUTION
NOTICE
that, if not avoided, will result in death of or
serious injury to the operator.
Indicates a potentially hazardous situation that,
if not avoided, will result in death of or serious
injury to the operator.
Indicates a potentially hazardous situation that,
if not avoided, could result in minor or moderate
injury to the operator.
Indicates potential risks of damage to the
supported product (or to other property).
WARNING
Do not use the product in the following
applications: medical use, nuclear power,
aerospace, those involving human lives such
as transportation, and those requiring high
reliability.
Hioki shall not be held liable for any accidents
resulting in injury or death or damage to the product
(or to other property) caused by use of the product in
such applications.
NOTICE
Do not use the LR8450-01 and its wireless
modules near other wireless communications
devices that use the 2.4 GHz frequency band.
Mounting the Wireless Module
on a Wall
You will need:
Mounting screws M4×8 mm or longer ..............................2
Mounting plate (accessory) ..............................................1
Flat-head screws M3×4 mm (accessory) .........................2
A Phillip’s head screwdriver (No. 2) .................................. 1
Secure the mounting plate onto the rear of the
1
wireless module with two at-head screws
(M3×4 mm, accessory).
NOTICE
www.hioki.com/
Warranty
Warranty malfunctions occurring under conditions of normal
use in conformity with the Instruction Manual and Product
Precautionary Markings will be repaired free of charge. This
warranty is valid for a period of three (3) years from the date
of purchase. Please contact the distributor from which you
purchased the product for further information on warranty
provisions.
Package Contents
LR8530 Wireless Voltage/Temp Unit
LR8531 Wireless Universal Unit
LR8532 Wireless Voltage/Temp Unit
LR8533 Wireless High Speed Voltage Unit
LR8534 Wireless Strain Unit
LR8535 Wireless CAN Unit …………… Any one of them
Z3230 Wireless LAN Adapter …………………………… 1
Z1008 AC Adapter
(3-prong grounded-type power cord) …………………… 1
Mounting plate ……………………………………………… 1
Flat-head screw M3×4 mm ……………………………… 2
Connection conrmation label (LR8534 only) ………… 1
Instruction Manual (this manual) ………………………… 1
When Sending the Module for Repair
Detach the Z3230 Wireless LAN adapter from the wireless
module and pack both of them.
Doing so may cause unstable communications or
aect the operation of other devices.
Install each wireless module (Z3230 Wireless LAN
Adapter) within a line-of-sight distance of 30 m
from the LR8450-01.
Keep clear of any obstacles, such as a wall and
metallic object, between the LR8450-01 and each
wireless module.
Failure to do so may cause unstable communications
or shorten a communication distance.
Attaching the Z3230 to the
Wireless Module
Turn o the wireless module and disconnect the AC
1
Adapter.
Do not connect any input cables.
Attach the Z3230 Wireless LAN Adapter to the top
2
side of the wireless module.
Insert the Z3230 as far as it will go.
Use the M3×4 mm at-head screws only.
Using other screws can damage the wireless module
or cause the wireless module to detach from the
mounting plate.
Rear
Secure the mounting plate on a wall with two M4
2
screws.
No mounting screws come with the wireless module.
Use commercially available screws.
Recommended screws: M4×8 mm or longer
Model names
Six dierent types of wireless modules are available for the
LR8450-01.
LR8530 Wireless Voltage/Temp Unit
LR8531 Wireless Universal Unit
LR8532 Wireless Voltage/Temp Unit
LR8533 Wireless High Speed Voltage Unit
LR8534 Wireless Strain Unit
LR8535 Wireless CAN Unit
Introduction
Thank you for choosing the wireless module dedicated to
Hioki LR8450-01 Memory HiLogger. The wireless modules
can wirelessly communicate with the LR8450-01 by attaching
the Z3230 Wireless LAN Adapter. For more information, such
as operating precautions and specications, see the Quick
Start Manual and Instruction Manual (PDF) included with the
LR8450-01.
Wireless LAN
The LR8450-01 Memory HiLogger communicates with the
Z3230 Wireless LAN Adapter using radio waves within the
2.4 GHz frequency band. No radio station licenses are
required; however, make sure to note the following points:
DANGER
Do not use the product near any medical devices,
including a heart pacemaker.
Radio waves emitted from the product can cause
medical devices, such as a heart pacemaker, to
malfunctions, resulting in accidents.
Tighten the captive screw of the Z3230.
3
NOTICE
Use the captive screw of the Z3230 only.
Using another screw can damage the wireless
module.
Front
CAUTION
Properly secure the mounting plate on a solid
wall.
Failure to do so can cause the wireless module to
fall, causing an accident resulting in injury or death or
damage to the wireless module.