Hioki 9596, 9597 Instruction Manual

Page 1
はじめに
このたびは、 ご選定いただき、誠にありがとうございます。この ードを十分にご活用いただき、末永くご使用いただくため にも、取扱説明書はていねいに扱い、いつもお手元に置い てご使用ください。
9596・9597
HIOKI
RAM
カードを
RAM
仕 様
PC C ard Standard
データ記憶容量
バックアップ用電池 寿命
使用温湿度範囲
寸法 付属品
準拠品 :1Mバイト(9596)
バイト(9597)
4M
CR2025
:2年以上(9596)(20℃参考値)
年以上(9597)(20℃参考値)
1
:0〜55℃、
と)
54.0(W)×85.6(H)×3.3(D) ( m m )
:リチウム電池 
取扱説明書   ソフトケース 
95%RH
1 1 1
以下(結露なきこ
1. 概要
本器は 用電池を1枚のカード状ケースに内蔵したメモリカードで す。各種の情報の外部記憶媒体として用いることができ、 大変便利です。
(読み出し書込み可能メモリ)とバックアップ
RAM
2. 電池のセットおよび交換の手順
カードを使用するときは、必ず指定のリチウム電
RAM
池をセットしてから使用してください。
●この電池は いたとき、あるいは機器の電源を カードに登録されているデータを保存するために使用し ています。
電池のセットおよび交換方法
電池交換は、5分以内に行ってください。 ①メモリカードの電池ホルダーのつめを押さえながら、電
池ホルダーを引き出してください。(図1参照)
②新しいリチウム電池の+面を上に向け、電池ホルダにセ
ットします。(図2参照)
③電池ホルダーの表裏をまちがえないように、メモリカー
ドに取りつけてください。(図3参照)
注記
データ登録後、不用意に電池を抜いて5分以上放 置すると、登録したデータが消失します。 重要なデータは必ずバックアップをとるようにし てください。 メモリカードの裏面の電池交換年月日記入欄に、 リチウム電池を入れた年月を記入し、次のリチウ ム電池の交換時期の目安にしてください。
カードを使用機器の差し込み口から抜
RAM
OFF
したとき、
RAM
つめ
カードの右上部に書込禁止ス イッ チが つい てい ま
RAM
す。
●このスイッチを〔← ると、
RAM
は困る大切なデータを登録してある ッチを〔←
 データを書き込む場合は、プロテクトを外して行い
注記
ます。
表面
出荷時は、ライトプロテクトスイッチは「書 き込み可」の位置になっています。データ書 き込みを禁止する場合は、「書き込み不可」の 位置にしてください。
2
電池ホルダ
1
3
WRITE PROTECT
カードは書込禁止の状態になります。消して
WRITE PROTECT
〕の位置にしておきます。
書き込み可
〕の位置に移動す
カードはスイ
RAM
書き込み不可
4. 使用上の注意
・直射日光や高温、多湿、結露するような環境下での、使
用はしないでください。変形、絶縁劣化を起こし、仕様
を満足しなくなります。 ・コネクタ部に指や金属などを触れないでください。 ・曲げたり、強い衝撃を与えないでください。 ・本器をぬらしたり、ぬれた手で測定すると感電事故にな
るので注意してください。 ・使用済の電池をショート、分解、火の中に投入しないで
ください。破裂する恐れがあり、危険です。 ・電池は寿命以内に交換してください。 ・電池交換は5分以内に行ってください。 ・リチウム電池は、幼児の手の届かない所に保管してくだ
さい。 ・一度メモリカードのデータが消失すると、新しいリチウ
ム電池と交換してもデータはもとには戻りません。 ・メモリカードを保管する場合には、コネクタ部にゴミや
ほこりが入らないように、ソフトケースに入れてくださ
い。 ・
カードをセットするときはて いね いに 扱っ てく だ
RAM
さい。 ・運用した結果の影響については責任を負いかねますので、
ご了承ください。
9596 9597
9596 9597
RAM CARD
取扱説明書
June 1998 Revised edition 1
日置電機株式会社 Printed in Japan
コネクタ部
表面
※お問い合わせは最寄りの営業所または本社販売支援課まで
9596A980‑01 98‑06‑0001H
再生紙を使用しています。
95969597 RAM カード
ライトプロテクト
電池ホルダ
Page 2
Introduction
r
W
Thank you for purchasing this HIOKI "9596/9597 RAM CARD." To ge t t he o p t imu m performance from this card, please rea d this manual first, and then keep it for future reference.
Specifications
Applicable standards
Data storage capacity
Back-up battery
Durability
Operating temperature and humidity range
Dimensions Accessories
PC card standard
1 Mbyte (9596) 4 Mbyte (9597)
CR2025
More than 2 years (9596) (20℃) More than 1 year (9597) (20℃)
0 ‑ 55℃, 95%RH or less (no condensation)
54.0(W)×85.6(H)×3.3(D) (mm) Lithium battery
Instruction Manual Soft case
2. Installing and replacing battery
Always insert the specified lithium battery
into the RAM c ard before use.
This battery is used to back-up data stored in the RAM card when it is removed from the slot in the equipment using the card, or when the power to the equipment is turne d off.
How to install, replace battery
Change the battery within 5 minutes.
Push the tab the battery holder, and pull out the holder. (Fig.1)
Set the + (plus) side of the new battery face up in the battery holder. (Fig.2)
Push the battery holder in to t he card until holder is flush with end of card. (Fig.3)
NOTE
If the battery is removed from the RAM card for more tha n 5 minutes, any data stored in the RAM card will be lost.
Make sure to back up the important data.
Keep a record of t he bat ter y replacemen t da ta on the back side of t he card.
3. RAM card write protect
The wri te pro tec t switch is located in th e
upper right portion of the RAM card.
When this switch is moved to the "←WRITE
PROTECT
" position, no da t a can be wri tt e n to the RAM card. The switch should be set to this position when important data has been written on the RAM card.
NOTE
In order to write data to the card, this write protect (data protect) switch m us t be switched off again.
Up side
The switch is on.
The switch is off.
the write protect switch is off (writable) initially. The cardcannotbewrittenwhentheswitchisonas shown.
Replace the lithium battery before it is exhausted in order to avoid the loss of data.
Change the batt ery within 5 minutes.
Keep children away from lithium batteries.
If data in the card is lost it can not be retrieved even if the battery is replaced.
Always keep the card put in the soft case when it is not in use.
Alw a ys han d le t h e RAM ca r d w it h c a r e, especially duri ng ins ert ion .
The manufact ure an d vendor cannot accept responsibility for direct or indirect damages arising from use of this RAM card.
Connecto
95969597 RAM CARD
Up side
rite-protect
switch
Battery holder
1. Outline
This memory card consists of RAM (Random­Access Memory) ch ip an d a bac k -u p batt e r y in a card-shaped case. It can be used as a convenient ext ernal storage medium for a variety of information.
Tab
Battery holder
Fig.1
Fig.3
Fig.2
8. RAM card handling precautions
Do n ot use the un i t wh ere i t will be exposed to direct sunlight, high tempera tu res, high humi dit y, or condensati on. If exposed to such conditions, the un i t ma y be dama ge d, t h e insulation may deteriorate, and the unit may no longer satisfy its specifications.
Do n ot touch connect ors with h a n ds or an y metallic object. Interna l circuit may be damaged by static electricity.
Do not drop, throw, abuse or bend the card.
To prevent electric shock, do not allow the card to become wet an d do not use the card when your hands are wet.
Do not disassemble th e card, or throw t he m in a fire. Doing so may cause the card to explode.
HEAD OFFICE
81 Koizumi, Ueda, Nagano 386-1192, Japan TEL +81-268-28-0562 / FAX +81-268-28-0568 E-mail: os-com@hioki.co.jp
HIOKI USA CORPORATION
6 Corporate Drive, Cranbury, NJ 08512, USA TEL +1-609-409-9109 / FAX +1-609-409-9108
9596A980-01 98-06-0001H
Printed on recycled paper
Loading...