Page 1
9442
PRINTER (DPU-414)
About Settings
November 2005 Revised edition 5 Printed in Japan
By changing some of the function settings (software DIP switches) this product can be used with the folÂlowing HIOKI instruments.
The following tables show the changes required in the settings.
For details of the method of making the settings, refer to the Instruction Manual for the DPU-414 from Seiko
Instruments Inc.
The initial setting is set up in TYPE A.
TYPE A
Adapted Model: 3169-20, 3169-21, 3167, 3286, 3286-20, 3330, 3331, 3332, 3333, 3351
(1) Software DIP SW1
Print density (%) Switch No.
(2) Software DIP SW2
Please change the printing mode corresponding to Model 3167 or Model 3330 printing item numbers. Model
3169-20, 3169-21, 3286, 3286-20, 3331, 3332, 3333, and 3351 are able to use it just as the initial state (40
line).
9442A980-05 05-11H
Use these settings.
Switch No. Function ON OFF
1 Input method Parallel
2 Printing speed
3 Auto loading
4 CR function
5 DIP SW setting command
6 to 8 Printing density See the table below
100
Switch No. Function ON1 OFF
1 Printing mode
2 to 8 It has been set to the DPU-414 default setting.
678
OFF ON ON
Carriage return and line feed
High Low
ON OFF
Enable Disable
40 lines 80 lines
Serial
Carriage return
(3) Software DIP SW3
Switch No. Function ON OFF
1 Data bit length
2 Parity permission
3 Parity condition
4 Flow control H/W BUSY
5 to 8 Baud rate See the table below
Baud rate (bps) Switch No.
9600
5678
OFF ON ON ON
8 bit 7 bit
Without With
Odd Even
XON/XOFF
TYPE B
Adapted Model: 3154, 3156, 3157, 3237, 3238, 3239, 3503, 3504, 3511-50, 3522-50, 3532-50, 3535
Use these settings.
(1) Software DIP SW1
Switch No. Function ON OFF
1 Input method Parallel
2 Printing speed
3 Auto loading
4 CR function
5 DIP SW setting command
6 to 8 Printing density See the table below
Print density (%) Switch No.
100
678
OFF ON ON
Carriage return and line feed
High Low
ON OFF
Enable Disable
(2) Software DIP SW2: It has been set to the DPU-414 default setting.
(3) Software DIP SW3
Switch No. Function ON OFF
1 Data bit length
2 Parity permission
3 Parity condition
4 Flow control
5 to 8 Baud rate See the table below
Baud rate (bps) Switch No.
19200
5678
OFF ON ON OFF
8 bit 7 bit
Without With
Odd Even
H/W BUSY XON/XOFF
HIOKI Model 1196 Recording Paper can be used as the thermal paper. As for the connecting cable, please
use the following.
Connecting cable Adapted model
9444 3154, 3156, 3237, 3238, 3239, 3331,3332, 3333, 3503, 3504 , 3511-50, 3535
9446 3157, 3167, 3330, 3522-50, 3532-50
9636 3286, 3286-20
9721 3169-20, 3169-21, 3351
Serial
Carriage return
Loading...