Page 1
Bulbs: 10 0W MED.
CARABEL
FR 44 62 1B CH
A S S EMBLY INSTRU C T I ONS
Assembly of this fixture will be accomplished by first assembling the main body,
installing the mounting hardware to the junction box, making all necessary electrical
connections and then hanging the fixture.
SAFETY WARNING: Read wiring and grounding instructions [FRIS 18]
and any additional directions. Turn power supply off during installation. If new wiring
is required, consult a qualified electrician or local authorities for code requirements.
ST E P 1
1
Slip cneter column (1) along wire and thread onto cuopler (a).
Remove ball knob with stud (2) from cage arm (c) - See Drawing 1. 2
3
shade with holes (c) on cage arms.
5
approximately 3/8”.
followed by rubber washer (9). Rubber washer will hold parts in position.
Slip shade (3) into the cage assembly (4). Making sure to line up holes (b) in
Thread ball knob and stud (2) into cage arm (c) to secure shade. 4
Thread stem (5) into coupler (d) located in the center of the socket assembly,
Slip cap (6) flat part up, onto stem (5) followed by tube (7) and hold in position. 6
Slip bottom cap (8) flat side down, onto stem (5) and over end of tube (7) ,
7
Fixture can now be lamped accordingly.
8
9
Slip rubber washer (11) onto stem (5), then thread hex nut (12) onto stem (5) and tighten
Slip acrylic lens (10) onto stem (5) and hold in position.
to secure acrylic lens.
10
Thread finial (13) onto end of exposed stem (5) to complete assembly.
[DRAWING 1]
d
5
6
7
8
12
11
1
a
9
13
c
b
2
10
4
3
S T E P 2 Refer to Hanging Instruction Sheet [FRIS19] to hang fixture.
8 00 .42 1. 35 17 W WW. FR ED RI CK RA MO ND. CO M
12.1.09
Loading...