Page 1
BENTLEY
FR 44 50 1B Bz
Bulbs: 60 W C AND. Replacement Parts: SHADE : R 44500 SH CRYST AL: R44500C RY
A S S E M BLY INSTRU C T I ONS
Assembly of this fixture will be accomplished by first installing the mounting strap to
the junction box, making all necessary electrical connections, mounting the fixture to
the ceiling, attaching the crystals, installing the candle sleeves and then attaching the shades.
[DRAWING 1]
j
SA FE TY WA RN ING: Read wiring and grounding instructions [FRIS 18]
and any additional directions. Turn power supply off during installation. If new wiring
is required, consult a qualified electrician or local authorities for code requirements.
S T E P 1
Assembly fixture by slipping center column (1) along wire and threading it onto
1
stem (2). Making sure arm of the spiders (3) line up equally spaced between the
arms (4) when it is tighten. It may be necessary to loosen hex nut inside canopy
(5) to adjust spider location. Making sure to re-tighten hex nut when aligned
correctly- See Drawing 2.
S T E P 2
1
Prepare mounting strap (a) by threading the two long mounting screws (b)
into the back of the mounting strap (a), making sure the holes into which the
screws are threaded match the spacing of holes (d) in the canopy (e) -
Drawing 1.
2 Attach mounting strap (a) to junction box (j) using two screws (c).
3 Make electrical connections from supply wire to fixture lead wires. Refer to
instruction sheet [FRIS18] and follow all instructions to make all necessary
wiring connections. Then refer back to this sheet to continue installation of
this fixture.
4 To mount fixture, slip the two mounting screws (b) through the two mounting
holes (d) in the backplate (e).
5 While holding fixture in place, thread the two ball knobs (f) on to the end of the
mounting screws (b), and tighten.
See
S T E P 3 Make electrical connections from supply wire to fixture lead wires.
Refer to instruction sheet (I.S. 18) and follow all instructions to make all necessary
wiring connections. Then refer back to this sheet to continue installation of this fixture.
S T E P 4
1
Slip stem cover (7) over stem (6) located at bottom of fixture.
2
Slip crystal bottom (8) over cover and hold in position, and
thread decorative knob (9) and tighten to secure crystal.
Slip candle sleeve (1) over socket (2) - see Drawing 2.
3
4
Slip shade cup (3) onto top of candle sleeve (2).
Thread tail (4) onto bottom of arm assembly (5).
5
Attach crystal pendalogues (6) to end of arms (7).
6
7
Fixture can now be lamped accordingly.
crystal 6
R44500CRY
12
11
10
b
a
c
e
d
f
[DRAWING 2]
5
3
1
2
4
6
7
8
9
8 00 .42 1. 35 17 WW W.F RE DR IC KR AMON D.C OM
01.01.10
Loading...