Hinkley Lighting FR43359PSS User Manual

XANADU

FR43359

Bulbs: 60W CAND. Replacement Parts: CRYSTALS: R43358CRY-A, R43358CRY-B

ASSEMBLY INSTRUCTIONS

Assembly of this fixture will be accomplished by first assembling the main fixture
body, installing mounting hardware to junction box, mounting main body to ceiling
and then installing the crystal body assembly.

SAFETY WARNING: Read wiring and grounding instructions [FRIS 18]

and any additional directions. Turn power supply off during installation. If new wiring
is required, consult a qualified electrician or local authorities for code requirements.

STEP 1

1 Prepare mounting strap (a) by threading the two 1 1/4” long mounting screws (b)

into the back of the mounting strap (a), making sure the holes into which the
screws are threaded match the spacing of holes (d) in the backplate (e) - See

Drawing 1.

2 Attach mounting strap (a) to junction box (j) using two screws (c).

3 Make electrical connections from supply wire to fixture lead wires. Refer to
instruction sheet [FRIS18] and follow all instructions to make all necessary
wiring connections. Then refer back to this sheet to continue installation of
this fixture.

4 To mount fixture, slip the two mounting screws (b) through the two mounting
holes (d) in the backplate (e).

5 While holding fixture in place, thread the two ball knobs (f) on to the end of the
mounting screws (b), and tighten.

STEP 2

This Xanadu flush mount uses 2 sizes of half pear crystal pendalogues.

1 Working from the top of the fixture down, attach smallest crystal pendalogues (1)
to eyelets (a) - See Drawing 2.

2 Attach medium size crystal pendalogues (2) to eyelets (b).

3 Repeat steps 1-3 for remaining scrolls.

[DRAWING 1]

j

b

a

c

e

d

f

[DRAWING 2]

a

b

a

eyelet

crystal 1

R43358CRY-A

crystal 2

R43358CRY-B

800.421.3517 WWW.FREDRICKRAMOND.COM

8.5.08