Hinkley Lighting FR42642SLF User Manual
CELESTE
FR42642SLF
Bulbs: 60W C AND. Rep laceme nt Par ts: GLA SS: FR42 640gl, fR42640CRY
ASSEMBLY INSTRU C T IONS
Assembly of this fixture will be accomplished by first installing the mounting strap to
the junction box, making all necessary electrical connections, mounting the fixture to
the wall, and then installing the crystal and fixture glass.
SAFETY WARNING: Read wiring and grounding instructions [FRIS 18]
and any additional directions. Turn power supply off during installation. If new wiring
is required, consult a qualified electrician or local authorities for code requirements.
ST E P 1
1 Prepare mounting strap (a) by threading tube into the center hole of
the mounting strap (a), approximately 1/4“- see Drawing 2.
2 Attach mounting strap (a) to junction box (j) using two screws (b) provided.
STEP 2
Refer to instruction sheet (I.S. 18) and follow all instructions to make all necessary
wiring connections. Then refer back to this sheet to continue installation of this fixture.
Make electrical connections from supply wire to fixture lead wires.
STEP 3
1 To mount backplate to wall, slip center hole of backplate (e) over nipple (c) and
hold fixture in position - see Drawing 2.
2 Thread decorative knob (d) onto end of nipple (c) and tighten to secure fixture.
[DRAWING 1]
j
a
b
c
e
[DRAWING 2]
4
d
ST E P 4
1
To install crystal (1) thread end into end of stem (2) until snug or in appropriate position.
2
Slip glass (3) over socket (s) - See Drawing 2.
3 Slip socket cover (4) over socket (S) making sure flat washer is facing down. Making
sure small tube on bottom of sleeve slips through bottom hole in glass.
4 Fixture can now be lamped accordingly.
3
s
1
2
800.42 1. 35 17 W WW. FR EDRI CKRA MOND. CO M
6.01.11
Loading...