MONTEREY
FR 42 50 0B ME
Bulbs: 2- 60W CAND . Replace ment Parts: SH ADE: R42502SH
A S S EMBLY INSTRU C T I ONS
Assembly of this fixture will be accomplished by first installing the mounting hardware
to the junction box, making all necessary electrical connections, mounting the
backplate to the wall and then installing the fixture shade.
SAFETY WARNING: Read wiring and grounding instructions [FRIS 18]
and any additional directions. Turn power supply off during installation. If new wiring
is required, consult a qualified electrician or local authorities for code requirements.
ST E P 1
1 Prepare mounting strap (a) by threading nipple into the center hole of
the mounting strap (a), approximately 1/4“- see Drawing 2.
2 Attach mounting strap (a) to junction box (j) using two screws (b) provided.
S T E P 2 Make electrical connections from supply wire to fixture lead wires.
Refer to instruction sheet (I.S. 18) and follow all instructions to make all necessary
wiring connections. Then refer back to this sheet to continue installation of this fixture.
S T E P 3
1 To mount backplate to wall, slip center hole of backplate (e) over nipple (c) and
hold fixture in position - see Drawing 2.
2 Thread decorative knob (d) onto end of nipple (c) and tighten to secure fixture.
3
Fixture can now be lamped accordingly.
j
a
2
[DRAWING 1]
b
c
[DRAWING 2]
e
d
3
ST E P 4
1 To install shade (1) slip crossbar (2) into brackets (3) - see Drawing 1
.
1
8 00 .42 1. 35 17 W WW. FR ED RI CK RA MO ND. CO M
01.01.11
Loading...