Page 1
BROADWAY
fR41430PAL
Bulbs: 60w g-9. Replacement Parts: GLASS : R 41430GL
A S S E M B LY INSTRU CTION S
Assembly of this fixture will be accomplished by first determining the length of stem
required, attaching the mounting strap to the junction box, making all necessary
electrical connections, hanging the fixture to the wall and then lamping the fixture.
SAFETY WA RNING: Read wiring and grounding instructions [FRIS 18]
and any additional directions. Turn power supply off during installation. If new wiring
is required, consult a qualified electrician or local authorities for code requirements.
STEP 1
1 Attach mounting plate (a) to junstion box (j) with screws provided -See Drawing 1
2 Make all wiring connections following instruction sheet (FRIS 18) provided.
Please follow all necesary precautions.
3 NOTE: Prior to mounting fixture to wall it should be determined if the glass will be
aligned horizontally or vertically.
[DRAWING 1]
a
j
[DRAWING 2]
b
c
d
d
3
4 After all connections are made, slip backplate (c) over mounting plate (a) and
hold in poistion while tightening screws (d). NOTE: As screws (d) are tighten
backplate will move backward and be flush against the wall.
5 Installation is complete and fixture can now be lamped.
STEP 3
1 To lamp fixture remove glass retainer ring (2) from main body (1). NOTE: the glass
retainer ring is held in position by spring tension and can be easily removed by pulling
firmly on the edge at the split line. Retainer ring is attached to the fixture by a wire
cable and will not fall when released - See Drawing 2.
Lamp fixture with bulbs provided and replace retainer ring by snapping in back in place.
2
STEP 4
1 Glass is held in glass retainer ring by a “C” shape spring ring (r). To remove, replace, or install glass
it is necessary to pinch the two short tabs (t) of the ring together, after glass is installed ring
can be replaced in same manner -see Drawing 3.
1
2
4
[DRAWING 3]
t
r
06.01.11
Loading...