Hinkley Lighting FR40600BKS User Manual

MUSE

FR40600BKS

Bulbs:60W g16-1/2 CAND. Replace ment Parts: GLASS : R40600 MIR; R4 0600OPAL

ASSEMBLY INSTRU C T IONS

Assembly of this fixture will be accomplished by first installing the mounting strap to
the junction box, making all necessary electrical connections, mounting the fixture to
the wall and then attaching fixture glass.

SAFETY WARNING: Read wiring and grounding instructions [FRIS 18]

and any additional directions. Turn power supply off during installation. If new wiring
is required, consult a qualified electrician or local authorities for code requirements.

ST E P 1

1 Prepare mounting strap (a) by threading the two longest mounting screws (b)

into the back of the mounting strap (a), making sure the holes into which the
screws are threaded match the spacing of holes (d) in the backplate (e) - See

Drawing 1.

2 Attach mounting strap (a) to junction box (j) using two screws (c).

3 Make electrical connections from supply wire to fixture lead wires. Refer to

instruction sheet [FRIS18] and follow all instructions to make all necessary
wiring connections. Then refer back to this sheet to continue installation of
this fixture.

4 To mount fixture, slip the two mounting screws (b) through the two mounting

holes (d) in the backplate (e).

5 While holding fixture in place, thread the two ball knobs (f) onto the end of the

mounting screws (b), and tighten.

[DRAWING 1]

j

a c e

b

[DRAWING 2]

f

d

1

2

3

ST E P 2

1 To install glass shades, remove socket ring (1) from threaded socket (5)

- See Drawing 2.

2 Slip mirrored glasss (4) over socket followed by opal glass (3).

3 Slip spacer (2) over socket and adjusted glassed (4) and (3) so it is level and center

on fixture.

4 Thread socket ring (1) onto socket (5) and tighten to secure glass.

5 Fixture can now be lamped accordingly.

4

5

800.42 1. 35 17 W WW. FR EDRI CKRA MOND. CO M

06.01.11