Hinkley Lighting FR40316SLF User Manual
FRANCESCA
FR40316SLF
Bulbs: 60W CAND. Replacement Parts: CRYS TALS: R40310CRY / R40310CRY-B / R40315CRY
[DRAWING 1]
A S S EMBLY INSTRU CTION S
Assembly of this fixture will be accomplished by first installing the mounting hardware
to the junction box, making all necessary electrical connections, mounting the fixture to
the ceiling and then attaching the crystals.
SAFET Y WAR NING: Read wiring and grounding instructions [FRIS 18]
and any additional directions. Turn power supply off during installation. If new wiring is
required, consult a qualified electrician or local authorities for code requirements.
STEP 1
1 To assembly fixture first take fixture arms (a) and rotate them until they are
approximately 60 degrees apart - see Drawing 1.
2 Slip loop (1) along supply wire and thread onto threaded tube (b) and tighten.
3 Slip candle sleeve (2) over socket (c).
4 Thread bottom decorative knob (3) onto threaded tube (d) at bottom of fixture.
STEP 2
1 It is recommend that the fixture be installed prior to attaching the crystals.
Please follow mounting instruction sheet [FRIS 19] provided to
hang the fixture.
2 After fixture is mounted please refer to crystal hanging instruction sheet to
complete fixture assembly.
60 degrees
a
a
a
[DRAWING 2]
1
b
a
a
a
2
c
a
d
3
01.01.12
FRANCESCA
FR40316SLF
Bulbs: 60W CAND. Replacement Parts: GL ASS : R40310CRY / R403 10CRY-B / R4 0315CRY
CRYSTAL INSTALLATION INSTRUCTIONS
There are 2 types of crystals that need to be installed on this fixture. It
is recommended that the flower crystals be attached first, followed by
the teardrop crystals, and then the compelted bobesches.
STEP 1 FLOWER CRYSTALS
1 All flower crystals (f) attach in the same manner. There locations
are illustrated in Drawing 1.
2 First remove ball knob with stud (b) and rubber washers (r)
from location (1) on Drawing 1.
3 To attach flower crystal, first slip rubber washer (r) onto stud (s),
next slip crystal flower (f) onto stud , followed by another
rubber washer (r) - see Drawing 2 below.
4 Thread stud (s) into end of arms at locations (1) on Drawing 1.
5 After flower crystal is secure, attach one tear drop crystal (t) to end of
ball knob stud (b).
[DRAWING 2]
r
1
R40310CRY-B
r
f
s
b
t
[DRAWING 1]
1
1
2
1
1
a
STEP 2 BOBESCHE ASSEMBLY
1 Take bobesche crystals (bc) and slip them over candle sleeve (cs).
- see Drawing 2 and 3.
2 Take a teardrop crystal (t) and attach to bobesche crystal (bc) at
location (2). Note: each bobeche requires 4 teardrop crystals.
3 One teardrop crystal is at tached at the base of the fixture at
location (3).
[DRAWING 3]
bc
R40310CRY
2
t
cs
R40315CRY
1
1
3
01.01.12
Loading...