Page 1
Item no. FR30824 / FR30825 / FR30826 / FR30827
Drawing 1 - Fixture Assembly
wire
stem
wire
stem
Assembly Instruction
MAYA
start here
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
s
wire
Drawing 2 - Fixture installation
J
B
A
D
C
Drawing 3 - Shade installation
1
G
E
3
3
1. Shut off electrical current before starting. If the fixture you are replacing is
turned on and off by a wall switch, simply turn the switch off. If not, remove
the appropriate fuse (or open the circut breakers) until the fixture is dead.
• DO NOT restore current - either by fuse, breaker or switch - until the new
fixture is completely wired and in place.
1. Determine the desired height the chandelier will be installed at.
2. The fixture is supplied with a variety of stem lengths. Determine what combination
of stems are needed to achieve desired length - see Drawing 1.
3. Slip stems over wire and thread first stem onto top of chandelier. Repeat this process
until all required stems are threaded together.
4. Slip wire through center of canopy swivel and thread onto stem assembly.
1. Prepare mounting strap (B) for mounting by installing screws (A) into mounting
plate (B) - see Drawing 2.
• Be sure the holes into which the screws are threaded match the spacing of holes (C)
in the canopy (D).
2. Attach mounting plate (B) to junction box (J), using screws (G) provided and slip
supply wires through large center hole.
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
R
5
4
6
5
1. Hang the fixture by slipping canopy (D) over screws (A) and holding in position - see
Drawings 2.
2. Thread ball knobs (E) onto end of screws (A) and tighten to secure fixture to ceiling.
1. To install shade (1) and glass (2), first slip glass (2) inside shade (1) and align top hole
in glass with center hole in shade ring (R), now slip both over socket (3) and hold
in position.
2. (4) over socket, then thread socket ring (5) onto socket (3) and tighten. Slip spacer ring
3. Fixture can now be lamped accordingly.
NOTE: Fixture can be assembled with shade only or glass only.
2
6.10.13
Loading...