Hinkley Lighting 5832 User Manual

Drawing 1 - Fixture Mounting

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com

A

BC C

assembly instructions

5832

Family: Alice Item No. 5832

start here

1. Find a clear area in which you can work.

2. Unpack fixture and glass from carton.

3. Carefully review instructions prior to assembly.

*** The construction of this fixture will be accomplished by first attaching the
mounting strap to the junction box, making all necessary electrical connections,
assembling the main body of the fixture, mounting the fixture to the wall,
and then installing the glass.

DE

F

Drawing 2 - Glass Installation

socket tool

3

4

6

5

2

1

5

1. Remove main mounting plate (A) from fixture back plate (B) by removing the four

flat head screws (C) - see Drawing 1.

2. Slide the wires from the junction box, through the large center hole, making sure
curved slots (D) line up with the threaded holes (E) in the junction box.

3. Using two 8-32 screws (F) attach the main mounting plate (A) to the junction box,
making sure top of mounting plate (A) is parallel to ceiling.

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.

1. Mount the fixture by sliding the back plate (B) over mounting plate (A) - see
Drawing 1.

2. Attach the back plate (B) to the mounting plate using the screws (F).

1. Prior to installing glass thread finial (1) into arm (2).

2. To install glass, remove the socket ring (3) and spacer (4) from the socket (5) - see

Drawing 2.

3. Place glass (6) over the socket (5).

4. Slip spacer (4) over socket and then thread socket ring (3) back on to socket (5) and

use socket tool provided to tighten. Note: Over tightening could cause damage to glass.

5. Fixture can now be lamped accordingly.

10.19.10