Page 1
Drawing 1 - Fixture Mounting
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com
assembly instructions
Family: Yorktown Item No. 5742 / 5743
start here
5743
5742
J
A
B C D
Drawing 2 - Glass Installation
socket
tool
2
3
4
back plate
E F
1. Find a clear area in which you can work.
2. Unpack xture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this xture will be accomplished by rst attaching the
mounting strap to the junction box, making all necessary electrical connections,
mounting the xture to the wall, and then installing the glass.
1. Prepare mounting strap (A) by threading the two long mounting screws (B)
into the back of the mounting strap (A) - see Drawing 1.
• Be sure the holes into which the screws are threaded match the spacing of holes (D)
in the backplate (E).
2. Attach mounting strap (A) to junction box (J) using two screws (C) provided.
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to xture lead wires. Refer to instruction sheet (I.S.
18) and follow all instructions to make all necessary wiring connections. Then refer back to this
sheet to continue installation of this xture.
1. To mount xture, slip the two mounting screws (B) through the two mounting holes (D) in the
backplate (E) - see Drawing 1.
2. While holding xture in place, thread the two ball knobs (F) on to the end
of the mounting screws (B), and tighten.
1
5
1. To install glass, remove socket ring (2 and spacer (3) from the socket (1) - see Drawing 2.
2. Slip glass (4) over socket (1).
3. Slip space (3) over socket and the thread socket ring (2) onto socket (1) and tighten using
supplied socket tool.
4. Repeat steps 1-3 for remaining glass.
01.01.12
Loading...