Hinkley Lighting 5555 User Manual

Drawing 1 - Strap Detail

A

F

B

assembly instructions

5555

Family: Avon Item No. 5555 CM

start here

1. Find a clear area in which you can work.

2. Unpack fixture and glass from carton.

3. Carefully review instructions prior to assembly.

G

Drawing 2 - Fixture Assembly

C D

4

3

2

1

*** The construction of this fixture will be accomplished by first mounting the
mounting strap to the junction box, making all necessary electrical connections,
mounting the fixture to the wall and then installing the fixture glass.

1. Remove ball knobs (C) from fixture - see Drawing 1.

2. Reomve retainer plate (A) from backplate (D).

3. Attach retainer plate (A) to junction box using 2 screws (B).

4. Additional screws (not provided) can be installed at points (E).

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to complete installation of this fixture.

1. Slip holes (G) in backplate (D) over screws (F) on retainer plate (A).

2. Thread ball knobs (C) onto end of screws (F) and tighten to secure backplate to wall.

5

HINKLEY LIGHTING 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com

1. To install glass, remove the spacer (3) and socket ring (4) from the socket (1) - see
Drawing 2.

2. Place glass (2) over the socket (1).

3. Slip spacer (3) and thread socket ring (4) back on to socket (1) and hand tighten.

Note: Over tightening could cause damage to glass.

4. Repeat steps 1-3 for remaining glass.

5. Fixture can now be lamped accordingly.

8.29.08