Hinkley Lighting 55484 User Manual
assembly instructions
Item No. 55482 / 55483 / 55484
55482
55484
55483
wall
anchor
Drawing 1 - Fixture Mounting
C
A
D
G
E
anchor
screw
Drawing 2 - Fixture Assembly
4
F
C
3
start her
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
B
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first mounting the
mounting strap to the junction box, making all necessary electrical connections,
mounting the fixture to the wall, and then installing the glass.
1. Remove main mounting plate (A) from fixture back plate (B) by removing the four
flat head screws (C) - see Drawing 1.
2. Slide the wires from the junction box, through the large center hole, making sure
curved slots (D) line up with the threaded holes (E) in the junction box.
3. Using two 8-32 screws (F) attach the main mounting plate (A) to the junction box,
making sure side of mounting plate (A) is square to ceiling.
4. Additional wall anchors supplied can be installed at keyhole points
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
e
(G)
.
1
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
1. Mount the fixture by sliding the back plate (B) over mounting plate (A) - see
2
5
HIN K L E Y LIGH T I N G 330 00 P in Oak Pa rk wa y Av on La ke , OH 440 12 8 00.4 46 .5 53 9 / 44 0. 65 3. 5500 h in kleylighti ng .c om
Drawing 1.
2. Attach the back plate (B) to the mounting plate (A) using the screws (C).
1. To install glass first unthread socket ring (3) from socket (1).
2. Slip glass (2) over socket (1).
3. Thread socket ring (3) onto socket (1), before tightening socket ring adjust glass.
4. Tighten socket ring (3) after adjusting glass. install G-9 lamp provided, and then
thread glass bulb shield (4) onto socket (1) and tighten till snug.
01.01.13
Loading...