Hinkley Lighting 5342 User Manual

Drawing 1 - Fixture Mounting

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com

assembly instructions

5342

Family: Mia Item No. 5342

A

D

Drawing 2 - Glass Installation

C

E

B

4

1

3

J

1. Find a clear area in which you can work.

2. Unpack fixture and glass from carton.

3. Carefully review instructions prior to assembly.

*** The construction of this fixture will be accomplished by first mounting the
mounting strap to the junction box, making all necessary electrical connections,
mounting the fixture to the wall and then installing the fixture glass.

1. Prepare mounting strap (A) by threading 1” nipple (C) into the center hole of the
mounting strap (A), approximately 1/4“ - see Drawing 1.

2. Attach mounting strap (A) to junction box (J) using two screws (B) provided.

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.

start here

1. To mount fixture, slip center hole of backplate (E) over nipple (C) and hold fixture in

2

5

position - see Drawing 1.

2. Thread decorative knob (D) onto end of nipple (C) and tighten to secure fixture.

1. To install glass, remove threaded socket ring (1) from socket (2) - see Drawing 2.

2. Place glass (3) over exposed section of socket (2).

3. Thread socket ring (1) onto socket (2) to secure glass (3).

4. Fixture can now be lamped accordingly.

5. Thread bulb shield (4) onto socket (2).

Note: Maximum wattage for 5342 fixture is 60 watts per G9 bulb.

9.14.09